UB-T780 - Panasonic Other Service Manuals Service Manual (repair manual). Page 14

14

When mounting on a wall, consult with your building's owner,
caretaker or construction manager to determine if the wall
strength is sufficient to install the elite Panaboard. For safety,
install the elite Panaboard only after thoroughly understanding
the type of walls, the appropriate types of screws and the con-
struction method.
Caution

Do not attach the electronic board to mortared walls. Acci-
dental electric leakage from the wall mounting plate bolts to
metal laths or wire laths can cause heat, smoke or a fire.

Drill, Screwdriver, Measuring tape, Level,
8 screws (M6 size)

1. Make sure that the wall is strong enough to support the

elite Panaboard.
greater than 1324 N (135 Kgf)
Notice

• If necessary, reinforce the wall so that it is strong enough

to support the elite Panaboard.

2. Make sure that the location is large enough to accommo-

date the elite Panaboard.
Height: greater than 2000 mm (6 ft 7 in)
Width: greater than 1850 mm (6 ft 1 in)

3. Make sure that the AC outlet is within 3 m (9 ft 10 

3

/

8

 in) of

where the elite Panaboard will be mounted and that it will
not be behind the elite Panaboard.

1. Ensure that the wall is strong enough to support the elite

Panaboard.
Rated strength: greater than 1324 N (135 Kgf)

2. Using the measuring tape and level, mark the 8 locations

to insert the screws.

• The dotted line in the illustration represents the outer

edge of the elite Panaboard.

3. Drill 8 holes for the wall mounting plates.

• Drill holes appropriate for the screws you are using.

4. Install the wall mounting plates using the 4 screws.

• 2 screws are used for each wall mounting plate.

The remaining 4 screws are used after installing the elite
Panaboard on the wall.

• Screws (8 count) are not included with the elite Pana-

board. Please prepare screws with a size of M6, appro-
priate for type of wall.

• Tighten the bolt so that it will not become loose.
• When drilling the holes and installing the wall mounting

plates, follow the procedure in the section 3.4.3 “Wall
Types and Installation Procedures”

5. Mount the elite Panaboard on the wall.

Refer to the section 3.6 “Assembling the elite Pana-
board”.