Read Panasonic KV-SS905C Service Manual online
··
Before setting SCSI ID, set “Wide SCSI” condition (Enable or Disable).
··
Setting the SCSI ID will be activated after turning the power OFF and turning it ON again.
··
Setting the terminator will be activated after turning the power OFF and turning it ON again.
4.13. Others
4.13.1. Selecting the paper path for scanned document
(1) To have the paper exit the front, set the pointer lever to the
upper side. The paper will exit through the front of the
scanner.
To select the straight path pass through to the back, set the
pointer lever to the lower side. The paper will exit through
the rear of the scanner.
scanner.
To select the straight path pass through to the back, set the
pointer lever to the lower side. The paper will exit through
the rear of the scanner.
Note
When scanning documents with a thickness of 0.2
mm to 1 mm, set the pointer lever to the straight
path. If the front exit is selected, the documents may
jam.
mm to 1 mm, set the pointer lever to the straight
path. If the front exit is selected, the documents may
jam.
4.13.2. Setting the ADF Selector
(1) When scanning normal paper [64 to 75 g/m
2
(17 to 20 lbs.)],
set the ADF selector to "3".
(2) When scanning thick paper or smooth sided paper, set the
ADF selector to "1" or "2".
(3) When scanning thin paper or rough face paper, set the ADF
selector to "4" or "5".
4.13.3. Scanning Multiple Sheet Paper
(1) When scanning multiple sheet paper, set the ADF selector
to the position as shown in the diagram at the right, then the
hopper moves to 1 sheet position.
hopper moves to 1 sheet position.
(2) Feed the multiple sheet paper document manually one by
one.
15
KV-SS905C
Click on the first or last page to see other KV-SS905C service manuals if exist.