Read Panasonic KV-S7075C (serv.man2) Service Manual online
108
Note:
*8
For LED and indicators’ position shown in the above figure, see Sec. 3.
7.
*9
CIS LED
Lamp Test
1 While holding down the “START/STOP Button” on the
Front Panel, turn on the scanner.
—
—
*9: Every time you
push the
“START/STOP”
Button, the lamp
status will change
periodically, as
follows.
push the
“START/STOP”
Button, the lamp
status will change
periodically, as
follows.
Lamp (F) ON
Lamp (B) OFF
Lamp (B) OFF
↓
Lamp (F) OFF
Lamp (B) ON
Lamp (B) ON
↓
Lamp (F) ON
Lamp (B) ON
Lamp (B) ON
↓
Lamp (F) OFF
Lamp (B) OFF
Lamp (B) OFF
↓
Lamp (F) ON
Lamp (B) OFF
Lamp (B) OFF
↓
2 Release the button after the LED (Back) status changes
to blinking.
Orange(Blinking)
→ Green
OFF
→
Blinking
3 Push the “START/STOP Button” once to enter the test
selection mode.
Green
Blinking
→
Count
4 Push the “START/STOP Button” once at the timing
when the LED (Back) status is 7 (h) *7.
Green
5 Pull the Exit Door Release to open the Exit Door.
Green
→ Red
6 Push the “START/STOP Button” once to turn on the
CIS LED Lamp (F).
Green
7 Push the “START/STOP Button” once to turn off the
CIS LED Lamp (F) and to turn on the CIS LED Lamp (B).
Green
8 Push the “START/STOP Button” once to turn on the
CIS LED Lamp (F) and CIS LED Lamp (B).
Green
9 Push the “START/STOP Button” once to turn off the
CIS LED Lamp (F) and CIS LED Lamp (B).
Green
10 Turn off the scanner to finish this test.
—
—
Click on the first or last page to see other KV-S7075C (serv.man2) service manuals if exist.