Read Panasonic F-VXL40R-S Service Manual online
12
5.2.4.
Disassembling of the switch box
1. Slide the switch box to remove.
2. Remove 5 screws in the figure of the main circuit board
and remove the board.
3. Disconnect the 6 connectors from the main circuit board.
*For some connectors, it is necessary to push a hook
to remove the connectors. Do not pull the connector
forcefully.
*Caution during assembly
• Make sure to wire the connectors by passing
between ribs during assembly.
• Be careful not to bend LEDs when the main circuit
board is installed to the switch box.
*For the names of each connector, refer to the block
diagram.
5.2.5.
Removal of the humidity sensor,
nanoe lead wire and lead switch
nanoe lead wire and lead switch
1. Remove the lead wire of the dust sensor from the wiring
termination rib.
*Caution during assembly
*Caution during assembly
Make sure to wire the connectors by passing between
ribs during assembly.
Click on the first or last page to see other F-VXL40R-S service manuals if exist.