Read Panasonic NN-S650WF Service Manual online
- 11 -
5. Door assembly
(A) Remove door C from door E by carefully pulling outward starting from
upper right hand corner using a flat blade screwdriver.
(B) Separate door E from tabs on door A and remove door A.
(C) Open Door E at the opening angle of approximately 10
°
(Note: The door
cannot be removed if the opening angle is greater than 10
°
).
(D) Remove the door from its hinges by pushing the door’s lower hinge pin
upward and out.
(E) Remove door screen B from door A.
(F) Remove door key and door key spring.
(G) When reassembling door hold door E at the opening angle of approximately
10
°
.
(H) Place the door’s lower hinge pin into the bottom hinge hole.
(I) Use your left index finger to support the door’s lower hinge pin while guiding
the door’s upper hinge pin into the top hinge hole.
(J) Lower your finger to seat the door onto the hinges.
(K) Replace other components.
(L)
Door alignment is crucial. If door is misaligned, apply pressure
until alignment is achieved.
After replacement of the defective component parts of the door,
reassemble, install, and perform microwave leakage test.
6. Turntable motor
(A) Remove the motor cover by breaking off at the 8 spots indicated by arrows with
a cutter or the like. (See Figure)
NOTE: After breaking off the motor cover, make sure that cut-off
portions are properly trimmed off or bend to inside so that
no sharp edge will expose to outside.
(B) Disconnect 2 lead wires connected to the turntable motor.
(C) Remove the turntable motor by removing 1 screw.
NOTE: After reinstalling the new turntable motor and reconnecting
the two lead wires, reinstall the motor cover by rotating it around 180 ,
tucking the tabs under the base into the 2 provided slots, then screw the
single tab to the base using a 4mm X 6mm screw (not provided).
DOOR
SCREEN B
SCREEN B
DOOR A
DOOR
KEY
KEY
DOOR
KEY
SPRING
KEY
SPRING
DOOR E
DOOR C
BASE
MOTOR
COVER
01-046
Click on the first or last page to see other NN-S650WF service manuals if exist.