Read Panasonic NN-GF574MZPE Service Manual online
6.6. Quartz heater
1. Disconnect lead wires from heater terminals.
2. Remove 1 screw holding reinfercement bracket & heater
2. Remove 1 screw holding reinfercement bracket & heater
mounting plate.
3. Remove another screw holding reinforcement bracket on
front plate, then remove reinforcement bracket.
4. Remove the heater by pulling it out.
6.7. Door assembly
1. Remove door C from door E by carefully pulling outward,
starting from upper right hand corner using a flat blade
screwdriver.
screwdriver.
2. Separate door E from tabs on door A and remove door A
(U).
3. Open Door E at the opening angle of approximately
10°(Note: The door cannot be removed if the opening
angle is greater than 10°).
angle is greater than 10°).
4. Remove the door E from its hinges by pushing the door E
upward and out.
5. Remove door key and door key spring.
To re-install components:
To re-install components:
1. Place the door’s lower hinge pin into the bottom hinge
hole.
2. Use your left index finger to support the door’s lower
hinge pin while guiding the door’s upper hinge pin into
the top hinge hole.
the top hinge hole.
3. Lower your finger to seat the door onto the hinges.
4. Replace other components.
NOTE:
4. Replace other components.
NOTE:
Adjust so that the upper portion of the door will
touch firmly to the oven cavity front plate, without
pushing the door. If the door assembly is not
mounted properly, microwave power may leak from
the clearance between the door and oven.
touch firmly to the oven cavity front plate, without
pushing the door. If the door assembly is not
mounted properly, microwave power may leak from
the clearance between the door and oven.
NOTE:
Always
perform
the
microwave
leakage
measurement test after installation and adjustment
of door assembly.
of door assembly.
14
NN-GF574M
Click on the first or last page to see other NN-GF574MZPE service manuals if exist.