NC-PH22WTW, NC-PH30WTW - Panasonic Home Appliance Service Manual (repair manual). Page 25

- 25 -

NC-PH22, NC-PH30

1. Pour water into the container and change to
    boiling state.
    (be sure to change to boiling state).
2. When 208F/98C LED is lighted, check 
    temperature in 1 hour later.

1. Pour water into container and press “Long
    Boil/Reboil” pad (Long Boil/Reboil LED
    will be blink), then set it to Long Boil mode.
2. Measure time until Keep Warm LED is going
    to be lighted.

Allowance    : 90˚C~100˚C 

(Should not be continuous boiling)

Allowance    :

1. Pour limited water into container and press
    Long Boil to No-Chlorine state.
    (Long Boil/Reboil LED will be lighted)
2. Measure time taken when 208F/98C LED
    blink until 208F/98C LED is going to lighted.

Long Boil time is approx. 80 sec.,
or less.

Allowance    : Long Boil time is approx. 6~9 min.

1. Pour limited water into container and set to
    boiling state.
2. Press “Select” pad 3 seconds up until
    208F/98C LED and Long Boil/Reboil going
    to lighted.
3. Measure time taken until 208F/98C LED
    going to blink.

Allowance    : Time for cleaning with citric acid

approx. 15~16 min., 20 seconds.

Allowance    : Amount of water should be

220±30 ml.

1. Pour water into the container and change to
    boiling state. Waiting to keep warm mode.
2. Measure amount of pouring-out water after
    change to keep warm state 1 hour.
3. Push on supporting plate to pump water for
    once and measure amount of pouring-out
    water.

For this test, please careful hot water.