Read Panasonic ES8161-E2 / ES8162-E2 / ES8163-E2 Service Manual online
1 SCHEMATIC DIAGRAM
2
2 DISASSEMBLY INSTRUCTIONS
3
3 CAUTION IN ASSEMBLY
5
2005 Works,
. and is a
of .
. and is a
of .
ES8161-E2
ES8162-E2
ES8163-E2
ES8162-E2
ES8163-E2
4 TROUBLESHOOTING GUIDE
7
5 EXPLODED VIEW & REPLACEMENT PARTS LIST
9
AC/Rechargeable Shaver
SPECIFICATIONS
Power source
AC 100-240V, 50-60Hz (Automatic voltage conversion)
Power consumption
DC5V 1A
Motor voltage
3.6V DC
Charging time
1 Hour
Shaves per charge
14 times (3 minutes shave)
Measurement
(H)15.3 x (W)6.2 x (D)4.6 cm
Weight
180g (without protective cap)
Supplied accessories
Soft case
Cleaning brush
CONTENTS
Page
Page
ORDER NO. SD0506E35C2
1 SCHEMATIC DIAGRAM
1.1. ES8161
1.2. ES8162
1.3. ES8163
2
ES8161-E2 / ES8162-E2 / ES8163-E2
Follow the procedure below to disassemble the main unit.
1. Remove the cap, the outer foil and the inner blade.
2. To remove the trimmer driving bar or the slit blade
driving bar, press bars outward.
3. Loosen a screw and remove the bottom cover. Set the
pivot action selector to "LOCK". Slide the back panel
and remove it with care of pivot action selector.
and remove it with care of pivot action selector.
4. Remove the housing clip.
Loosen four screws and remove housing B.
Take out the lock lever shaft.
Take out the lock lever shaft.
5. Set the trimmer at about 8mm sliding above. To unhook
the right and left side of upside hooks, slightly pull the
trimmer forward. Then, slightly pull the trimmer in each
side.
trimmer forward. Then, slightly pull the trimmer in each
side.
6. Take out the tube holder.
2 DISASSEMBLY INSTRUCTIONS
3
ES8161-E2 / ES8162-E2 / ES8163-E2
7. Move gently the linear motor assembly down and
unhook it and remove the float springs from housing A.
8. Pull up the battery and chassis block from the linear
motor side first. Then, slide it upward and take it out
from the housing A.
NOTE:
from the housing A.
NOTE:
Do not pull the battery and chassis block forcefully
due to connecting the linear motor by the lead wires.
due to connecting the linear motor by the lead wires.
9. Take out the battery from the chassis.
10. Unsolder the lead wires from the module.
4
ES8161-E2 / ES8162-E2 / ES8163-E2