ES-LA83, ES-LA63 - Panasonic Home Appliance Service Manual (repair manual). Page 9

9

When reassembling, replace the new waterproof seal.  Make sure whether there is NO foreign substance sticking around a part
covered with waterproof seal.

1. Solder the lead wires with the module.

Make sure of the color of lead wires.

2. Attach the tube holder.  Tighten two screws between the

linear motor assembly and the housing A.

3. When inserting the module and chassis block into the

housing A, confirm if the module does not get any dam-
age or deformation.

Comfrm the position of waterproof rubber.

4. Make sure that the lead wires set in position to avoid

abnormal noise. Install (+) terminal of battery into the ter-
minal plate at the bottom cover side and firmly set the bat-
tery sliding the direction of arrow.  Attach (-) terminal of
battery.
NOTE:

Once taking the battery out, the shaver is RESET.
The shaver must be charged for about 10 seconds
first.

Completely discharge and then fully charge before
returning the shaver to the customer.