Read Panasonic EH-NE70 / EH-NE60 Service Manual online
7
4. Install the high voltage block to housing B and allocate
the lead wires as shown in the following.
a. Allocate the all lead wires between the ribs.
b. Allocate the all lead wires underneath the plate.
b. Allocate the all lead wires underneath the plate.
c. Arrange the black insulation tube over the lead wires.
5. Allocate the switch block and insulation tube of the power
cord on the handle.
a. Insert the switch plates between the switches by fitting
the hole of the switch plate to the plate of the switch.
b. Allocate the gray insulation tube of the power cord to
over the following line A-A.
6. Allocate the capacitor and PCB on the electrification
panel, then arrange the lead wire and insulation tube as
shown in the following. Stick the aluminum seal
(20.0x9.0) over the tip of white lead wire.
shown in the following. Stick the aluminum seal
(20.0x9.0) over the tip of white lead wire.
7. Insert the swivel ring to the housing so that the marking
points downward.
Click on the first or last page to see other EH-NE70 / EH-NE60 service manuals if exist.