Read Panasonic DMP-BDT130EE / DMP-BDT330EE Service Manual online
38
2. After applying a small amount of lubricants to the both
ends of Drive Shaft (A), insert the Optical Pick-Up Unit
into the Drive Shaft (A), then insert them into shaft hole of
the base.
Attach the other side of Optical Pick-Up on the Drive
Shaft (B), then set 2 damper springs and lock the drive
shaft (A) to the base.
into the Drive Shaft (A), then insert them into shaft hole of
the base.
Attach the other side of Optical Pick-Up on the Drive
Shaft (B), then set 2 damper springs and lock the drive
shaft (A) to the base.
Caution:
Do not stick any foreign bodies to the shaft during
assembly.
assembly.
3. Attach the Middle Base to the traverse unit.
4. Insert FFC, and desolder the solder spot.
a. Use the iron head with an angle as shown in
Fig,remove the solder in the direction as shown.
b. Set the temperature of iron below 350
°C.
c. When using the iron head,do not apply a force more
than 1N to the pad. Do not touch any other compo-
nents around the welding spot.
nents around the welding spot.
d. Welding should be applied less than 3 seconds.
Click on the first or last page to see other DMP-BDT130EE / DMP-BDT330EE service manuals if exist.