Read Panasonic H-HS35100PP / H-HS35100E / H-HS35100GK Service Manual online
16
4.4.
Assembly procedure
Important:
When tightening the screw, use a torque driver (RFKZ0456)
by ordering the screwing order with specified torque
described in each step.
by ordering the screwing order with specified torque
described in each step.
4.4.1.
Installation of the 1st lens block
1. Put the 1st lens block to original position (Don't rotate.)
Then, tighten the 3 screws (B) with specified torque in
numerical order.
(Torque: 14±1N ･ cm)
numerical order.
(Torque: 14±1N ･ cm)
2. Install the 1st dust proof rubber.
4.4.2.
Installation of the Lens top unit
1. Tighten the 3 screws (A) with specified torque in numeri-
cal order.
(Torque: 16±1N ･ cm)
(Torque: 16±1N ･ cm)
4.4.3.
Installation of the Decoration ring
1. Please insert the pin of the Decoration ring to the hole of
the Lens top unit.
• Use new one, do not use the one which is removed.
• Double-stick tape sticks to the Decoration ring of the
• Double-stick tape sticks to the Decoration ring of the
repair part.
Please remove the old double-stick tape from the Lens
top unit.
Please remove the old double-stick tape from the Lens
top unit.
2. After installing the Decoration ring, use a soft cloth to
press it into place.
Click on the first or last page to see other H-HS35100PP / H-HS35100E / H-HS35100GK service manuals if exist.