Read Panasonic H-H014PP / H-H014E / H-H014GK Service Manual online
11
5.3.
Method of cleaning inside of lens
5.3.1.
Disassembly Procedure
IMPORTANT
It must be performed inside of satisfied clean level.
(Satisfied clean level: Less than class 10,000 Federal
Standard 209D).
(Satisfied clean level: Less than class 10,000 Federal
Standard 209D).
1. Removal of the Decoration Ring
*.Decoration ring is sticked on the 1st lens frame unit.
*.Put the sheet so that the lens glass is fully covered.
*.Insert the needle to Gap “A” (between the Decoration
ring and Lens glass), and peel off the Decoration ring
gentlly.
*.Put the sheet so that the lens glass is fully covered.
*.Insert the needle to Gap “A” (between the Decoration
ring and Lens glass), and peel off the Decoration ring
gentlly.
2. Removal of the 1st Lens frame unit
*.Remove 3 screws (A).
*. Blow off the dust on the surface of the lens with a blower
brush.
*. Use lens cleaning KIT (BK)(VFK1900BK), if necessary.
5.3.2.
Assembly Procedure
IMPORTANT NOTICE:
*.When tightening the screw, use a Torque driver
(RFKZ0456) by ordering the screwing order with specified
torque descrived in each step.
(RFKZ0456) by ordering the screwing order with specified
torque descrived in each step.
1. Installation of the 1st Lens frame unit
*Tighten the 3 screws (A) with specified torgue in
numerical order.
numerical order.
2. Installation of the Decoration ring
*Install the Decoration ring by referring the phase mark.
(Use new one, Do not use the one which is removed.)
(Use new one, Do not use the one which is removed.)
* After installing the Decoration ring, press the decoration ring
with your finger.
Click on the first or last page to see other H-H014PP / H-H014E / H-H014GK service manuals if exist.