DMC-G3KEE - Panasonic Digital Camera Service Manual (repair manual). Page 14

14

After replacing the MAIN P.C.B., make sure to perform the initial settings after achieving the adjustment by ordering the following
procedure in accordance with model suffix of the unit.
1. IMPORTANT NOTICE:

Before proceeding Initial settings, make sure to read the following CAUTION.

• Precautions: Read the above “CAUTION” carefully.
• Preparation:

Attach the fully charged Battery, and insert the SD memory card.
Confirm that it is not intelligent auto mode [iA] or intelligent auto plus mode [iA+]. 
NOTE:
If the unit is intelligent auto mode [iA] or intelligent auto plus mode [iA+], it does not display the initial settings menu.

• Step 1. The temporary cancellation of “INITIAL SETTINGS”:

While pressing [ Q.MENU/Fn2 ], [ DISP/Fn1 ] and “[ RIGHT ] of Cursor buttons” simultaneously, turn the Power on.

• Step 2. The cancellation of “INITIAL SETTINGS”:

Press the [ PLAYBACK ] button, then playback the picture.
Press [ Q.MENU/Fn2 ] and “[ UP ] of Cursor buttons” simultaneously, then turn the Power off.

• Step 3. Turn the Power on:

SEt the mode dial to [ P ] (Program AE Mode), then turn the Power on. 

• Step 4. Display the INITIAL SETTING:

While pressing “[ RIGHT ] of Cursor buttons” and [ MENU/SET ] simultaneously, turn the Power off. 
The “INTIAL SETTINGS” menu is displayed.
There are two kinds of “INITIAL SETTINGS” menu form as follows:
[CASE 1. After replacing MAIN P.C.B.]

[Except "EG, EB, EC and OLY" models : (VEP56135A is used as a Main P.C.B.)]
When MAIN P.C.B. has just been replaced, all of the model suffix are displayed as follows. (two pages in total)