Read Panasonic DMC-G10KPP / DMC-G10KEB / DMC-G10KEC / DMC-G10KEG / DMC-G10KGC / DMC-G10KGD / DMC-G10KGH / DMC-G10KGT / DMC-G10KGK / DMC-G10KGN / DMC-G10WGC / DMC-G10WGH / DMC-G10WGN Service Manual online
DMC-G10KEB
DMC-G10KEC
DMC-G10KEG
DMC-G10KGC
DMC-G10KGD
DMC-G10KGH
DMC-G10KGT
DMC-G10KGK
DMC-G10KGN
DMC-G10WGC
DMC-G10WGH
DMC-G10WGN
(K)...........Black Type
1.2. Leakage Current Cold Check ---------------------------3
1.3. Leakage Current Hot Check (See Figure 1.) --------3
1.4. How to Discharge the E. Capacitor on POW
2.4. How to Replace the Lithium Battery -------------------7
3.2. Important Notice --------------------------------------------8
3.3. General Description About Lead Free Solder
5 Location of Controls and Components ------------------ 17
6 Service Mode ----------------------------------------------------- 21
8.2. Clean Box -------------------------------------------------- 29
8.3. Service Position ------------------------------------------ 30
9.2. Disassembly and Assemble Procedure for the
11.2. General description (Lens cleaning:
which are important for safety. These parts are marked by
tial that these critical parts should be replaced with manu-
facturer’s specified parts to prevent X-RADIATION,
shock, fire, or other hazards. Do not modify the original
design without permission of manufacturer.
from the AC power line. Use a transformer of adequate
power rating as this protects the technician from acci-
dents resulting in personal injury from electrical shocks. It
will also protect AC Adaptor from being damaged by acci-
dental shorting that may occur during servicing.
heated or damaged by the short circuit.
properly installed.
shock hazards.
lic cabinet part on the equipment such as screwheads,
connectors, control shafts, etc. When the exposed metal-
lic part has a return path to the chassis, the reading
should be between 1 M
reading must be infinity.
(See Figure 1.)
and a good earth ground, as shown in Figure 1.
lent) may be used to make the hot checks, leakage cur-
rent must not exceed 1/2 mA. In case a measurement is
outside of the limits specified, there is a possibility of a
shock hazard, and the equipment should be repaired and
rechecked before it is returned to the customer.
2. Be careful of the high voltage circuit on POW FLASH P.C.B. when servicing.
2. Put the insulation tube onto the lead part of Resistor (ERG5SJ102:1k
4. After discharging confirm that the E. Capacitor voltage is lower than 10V using a voltmeter.