WV-CS950, WV-CS954E - Panasonic Video Monitoring Service Manual (repair manual). Page 22

2-16

y

After confirming that there is no other object between the
Camera and the Radiation Chart, press the ENTER key.

u

Wait about 40 seconds until finishing the Back Focus
adjustment.

i

Confirm that the picture is clearly visidle during zooming
wide.

o

If the picture is not clearly viside, press ESC key, and
select the item "1.2. BACK FOCUS ADJ" with the
ARROW key, and press the ENTER key.

!0

Repeat above adjustment steps 

y 

to 

o 

until the picture

becomes fine.

!1

After completing of the adjustment, press the QUIT (F3)
key.

!2

If you want to save, press the Y key, and then press the
ENTER key, Type xxxxxxxx.EV2 B40 19FF. Give an
appropriate file name for xxxxxxxx within 8 letters, but
do not use CS95E. Then press the ENTER key to finish
this adjustment procedure.

!3

If you don't want to save, press the N key, and then press
the ENTER key to finish this adjustment procedure.

Note: This Tilt Adjustment is required in the following cases;

1. Replacing the CCD image sensor.
2. Replacing the Sensor Board.
3. Replacing the Tilt Board.

8

Insert new floppy disk containing DOS Operating System
and the E.V.R. Adjustment Program into the computer
(IBM PC/AT) and turn on the Power Switch of the com-
puter.

8

When starting an adjustment, at the prompt, type
RADJ2 CS95TLT and press the ENTER key, an initial
menu page as shown in Fig. 4-3-1 will be displayed.

This saving procedure is recommended to keep the current
adjustment status of the camera.

8

Press the SAVE (F5) key of the computer, and the com-
puter will ask you for the file name.

8

Type  xxxxxxxx.EV2 B40 19FF. Give an appropriate file
name for xxxxxxxx within 8 letters, but do not use
CS95E.

8

Press the ENTER key.

This loading procedure is recommended to return the adjust-
ment status of the camera to the factory default setting or
the setting you saved before.

8

Press the LOAD (F1) key of the computer, and the com-
puter will ask you for the file name.

8

Type  CS95E.EV2 or  xxxxxxxx.EV2 (xxxxxxxx means a
file name you named before.) and press the ENTER key.

PANASONIC REMOTE EVR ADJUSTMENT SYSTEM CCTV PRODUCT: CS950 EEPROM:0

✽   ✽   ✽   ✽   ✽   ✽   ✽  ✽   ✽  ✽   ✽  ✽  ✽   ✽   ✽   ✽   ✽   ✽  ✽  ✽  ✽  ✽  ✽ 

MENU

✽   ✽   ✽   ✽   ✽   ✽   ✽   ✽   ✽   ✽    ✽   ✽   ✽   

Page (1/1)

✽   ✽   ✽  ✽   

NTSC

1. PAN/TILT POSITION-1
2. PAN/TILT POSITION-2
3. TILT RE-ADJ
4. PAN/TILT POSITION-1
5. PAN/TILT POSITION-2

<CONTENTS>    PAN/TILT
<INSTRUCTION> PLEASE CHOOSE MENU DATA BY ARROW-KEY

LOAD (F1)          QUIT (F3)             SAVE (F5)