Read Panasonic WV-CF224E Service Manual online
2-7
(7.3). 3 200°K Phase Adjustment
Test Point:
Video Output Connector
8
Keep the Colour Temperature at 3 200°K.
8
Aim the Camera at the Colour Chip Chart.
8
Adjust data with the ARROW keys so that the Red vector
phase becomes 108° ± 2°.
phase becomes 108° ± 2°.
8
Repeat adjustment steps (7.1). to (7.3). until both chromi-
nance phase and gain are adjusted to proper position as
shown in Fig. 4-8 and Table 4-2.
nance phase and gain are adjusted to proper position as
shown in Fig. 4-8 and Table 4-2.
Table 4-2
8
Press the ENTER key for next adjustment.
Red
±
2˚
220 %
±
5 %
Phase
Gain
Yellow
±
5˚
100 %
±
5 %
108˚
160˚
cy
g
M
G
Y
L
yl
B
b
G
C
Y
dG
10
°
0
°
10
°
dø
100%
75%
R
V
U
mg
r
20%
20%
dG
(6.3). Burst Level Adjustment
Test Point:
Video Output Connector
8
Keep the Colour Temperature at 3 200°K.
8
Aim the Camera at the Logarithmic Gray Scale Chart.
8
Connect the terminated Oscilloscope with 75
Ω
to Video
Output Connector.
8
Adjust data with the ARROW keys so that the data
becomes –
becomes –
α
from noted data.
8
Press the ENTER key for next adjustment.
(6.4). Burst Level Adjustment
Test Point:
Video Output Connector
8
Keep the Colour Temperature at 3 200°K.
8
Aim the Camera at the Logarithmic Gray Scale Chart.
8
Connect the terminated Oscilloscope with 75
Ω
to Video
Output Connector.
8
Adjust data with the ARROW keys so that the data
becomes +
becomes +
α
from noted data.
8
Press the ENTER key and ROLL DOWN Key.
8
Repeat adjustment steps (6.1) to (6.4) until Burst Level
and Phase are adjusted to proper position as shown in
Fig. 4-6 and 4-7.
and Phase are adjusted to proper position as shown in
Fig. 4-6 and 4-7.
8
Press the ENTER key for next adjustment.
(7.1). 3 200°K R Gain Adjustment
Test Point:
Video Output Connector
8
Keep the Colour Temperature at 3 200°K.
8
Aim the Camera at the Colour Chip Chart.
8
Adjust data with the ARROW keys so that the Red gain
becomes 220 % ± 5 %.
becomes 220 % ± 5 %.
8
Press the ENTER key for next adjustment.
Note: Chrominance phase and gain are adjusted to proper
position as shown in Fig. 4-8 and Table 4-2.
(7.2). 3 200°K B Gain Adjustment
Test Point:
Video Output Connector
8
Keep the Colour Temperature at 3 200°K.
8
Aim the Camera at the Colour Chip Chart.
8
Adjust data with the ARROW keys so that the Yellow gain
becomes 100 % ± 5 %.
becomes 100 % ± 5 %.
8
Press the ENTER key for next adjustment.
Note: Chrominance phase and gain are adjusted to proper
position as shown in Fig. 4-8 and Table 4-2.
Fig. 4-8
Click on the first or last page to see other WV-CF224E service manuals if exist.