Read Panasonic WJ-SX150 / WJ-SX150A Service Manual online
– 1-1 –
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
Matrix Switcher WJ-SX
OPERATE
q
0
9
8
7
6
5
4
3
2
1
MODE
UNIT
RESET
w
e
r
1
ON
2 3 4
150A
■
Front View
q
Operation indicator (OPERATE)
Lights up when the power of the unit is turned on.
Note: The indicator will blink to indicate rising tempera-
ture in the matrix switcher.
w
Reset button (RESET)
Resets and restarts the unit.
Resets and restarts the unit.
Note: The system configuration is not reset.
e
Unit number selector (UNIT)
Normally, set this selector to “0”.
When applying the master-slave connection, set this
selector to one of the following unit numbers.
Normally, set this selector to “0”.
When applying the master-slave connection, set this
selector to one of the following unit numbers.
Master/Slave
Unit number
Master
0
Slave 1
1
Slave 2
2
Slave 3
3
Slave 4
4
r
Mode selector (MODE)
Selects the unit's operation mode.
Normally, set all switches to OFF (NORMAL mode) as
shown in the figure.
Selects the unit's operation mode.
Normally, set all switches to OFF (NORMAL mode) as
shown in the figure.
SX150A SOFTWARE UPLOAD:
Set the switches to this position when you update
the firmware of the unit. (Refer to the operating
instructions of the Multiplexer board.)
the firmware of the unit. (Refer to the operating
instructions of the Multiplexer board.)
MULTIPLEXER SOFTWARE UPLOAD:
This mode is reserved for future use.
1
ON
2 3 4
1
ON
2 3 4
1
ON
2 3 4
NORMAL
SX150
SOFTWARE UPLOAD
SOFTWARE UPLOAD
MULTIPLEXER
SOFTWARE UPLOAD
SOFTWARE UPLOAD
MODE SW SETUP
Click on the first or last page to see other WJ-SX150 / WJ-SX150A service manuals if exist.