Read Panasonic WJ-HDE500B / WJ-HDE505B / WJ-HDE510B Service Manual online
– 2 –
APPEARANCE OF WJ-HDE510B
<FRONT VIEW>
q
Operate Indicator [OPERATE]
Lights in green while the power is supplied to the unit.
Lights in orange when a thermal error is detected inside
the unit.
Lights in orange when a thermal error is detected inside
the unit.
w
HDD indicator [HDD 1] [HDD 2]
Lights in green while the HDD is accessed. Do not turn
off the POWER switch while any of the access indicators
is lit.
off the POWER switch while any of the access indicators
is lit.
e
DVD-RAM lid
Protects the DVD-RAM drive from dust. Press this lid to
install the DVD-RAM disk. The DVD-RAM lid normally
should be kept closed to prevent dust from entering the
drive.
install the DVD-RAM disk. The DVD-RAM lid normally
should be kept closed to prevent dust from entering the
drive.
r
HDD lid
Two HDD openings are provided inside the DVD
Extension Unit. Remove this lid to install the HDD.
Replace the lid after installing the HDD.
Extension Unit. Remove this lid to install the HDD.
Replace the lid after installing the HDD.
t
DVD-RAM drive [tray]
y
Busy indicator
Lights in green when a DVD-RAM is installed in the DVD
Extension Unit.
It changes to orange while the DVD-RAM Drive is run-
ning.
Extension Unit.
It changes to orange while the DVD-RAM Drive is run-
ning.
WJ-HDE
B
Unit
Extension
HDD
HDD
2
1
OPERATE LED WILL CHANGE TO ORANGE
IF THE INSIDE TEMPERATURE EXCEEDS OR FALLS BELOW THE LIMIT.
IF THE INSIDE TEMPERATURE EXCEEDS OR FALLS BELOW THE LIMIT.
OPERATE
●
Front View
u
Eject hole
i
Open/Close button
Is used for insertion or removal of the DVD-RAM disk
while the DVD-RAM lid is opened.
while the DVD-RAM lid is opened.
<REAR VIEW>
o
Hard Disk Detection switch
[HDD INSTALLED/ NOT INSTALLED]
[HDD INSTALLED/ NOT INSTALLED]
Detects an optional HDD when one is installed.
!0
SCSI Output connector [EXT OUT]
Connect another Extension Unit with an SCSI cable.
!1
SCSI Input connector [EXT IN]
Connect the WJ-HD500 or another Extension Unit with
an SCSI cable.
an SCSI cable.
!2
SCSI ID switch [SCSI ID –/+]
Press the – or + selector with a small headed screwdriv-
er to select the desired SCSI ID in the chain.
er to select the desired SCSI ID in the chain.
!3
Termination switch [TERMINATOR ON/OFF]
Set this switch to ON for an Extension Unit that is located
at the end of the SCSI chain. Otherwise set it to OFF.
at the end of the SCSI chain. Otherwise set it to OFF.
●
Rear View
SCSI ID
TERMINATOR
-
+
1
GND
ON
OFF
SIGNAL
AC IN
POWER
EXT IN
COPY IN
EXT OUT
G
NC
THERMAL ERROR OUT
ON
OFF
OFF
HDD
INSTALLED
NOT INSTALLED
NOT INSTALLED
Click on the first or last page to see other WJ-HDE500B / WJ-HDE505B / WJ-HDE510B service manuals if exist.