Read LG WP-9526S Service Manual online
7.
Fig. 38
Fig. 39
Fig. 40
Fig. 41
Fig. 42
6. Unscrew the pulsator pulley fixing bolt and remove
the pulsator pulley(Fig. 38).
Unscrew and remove the screws fastening the gear
case assembly at the tub(Fig. 39).
case assembly at the tub(Fig. 39).
1.
Don't disassemble four screws fixing the
gear case assembly.
2.
Check the assembled condition of the
packing-P at the tub hole is right when you
assembled the gear case assembly (fig. 40).
NOTE
4-8. Bellows Assembly Replacement
NOTE
The bello
ws assemb
ly attached to the unit
cannot be remo
ved unless it is tor
n off.
After removing the spin dryer basket assembly, refer
to the figures and proceed as follows:
to the figures and proceed as follows:
Remove the bellows assembly (Fig. 41).
1.
Remove the bellows supporter by using slip joint
pliers to the spin tub bottom (Fig. 41).
pliers to the spin tub bottom (Fig. 41).
2.
Bellows assembly
Insert the bellows assembly into the bellows
supporter (Fig. 42).
supporter (Fig. 42).
1.
The assembly procedure is as follows:
Fit them by pushing the bellows assembly and the
bellows supporter at the same time in the spin tub
bottom (Fig. 42).
bellows supporter at the same time in the spin tub
bottom (Fig. 42).
2.
Pass the spin shaft through the center hole of the
bellows assembly and insert it into the coupling
assembly (Fig. 42).
bellows assembly and insert it into the coupling
assembly (Fig. 42).
2.
-12-
Click on the first or last page to see other WP-9526S service manuals if exist.