Read LG WP-620N Service Manual online
12
Nut
5. Unscrew the pulsator pulley fixing bolt, the nut,
remove the pulsator pulley (Fig. 39).
6. Unscrew and remove the screws fastening the
P.shaft assembly at the cabinet (Fig. 40).
To assemble the P.shaft assembly (Gear case assembly)
to the cabinet, reverse the above disassembly.
to the cabinet, reverse the above disassembly.
After removing the spin dryer basket assembly, refer
to the figures and proceed as follows:
to the figures and proceed as follows:
1. Remove the bellows assembly (Fig. 42).
2. Remove the bellows supporter by using slip joint
pliers to the spin tub bottom (Fig. 42).
The assembly procedure is as follows:
1. Insert the bellows assembly into the bellows
supporter (Fig. 43).
2. Fit them by pushing the bellows assembly and the
bellows supporter at the same time in the spin tub
bottom (Fig. 43).
bottom (Fig. 43).
3. Pass the spin shaft through the center hole of the
bellows assembly and insert it into the coupling
assembly (Fig. 43).
assembly (Fig. 43).
NOTE
1. Don't disassemble three screws fixing the
P.shaft assembly.
2. Check the assembled condition of the
packing-P at the cabinet hole is right when
you assembled the P.shaft assembly(Fig. 41).
you assembled the P.shaft assembly(Fig. 41).
NOTE
The bellows assembly attached to the unit
cannot be removed unless it is torn off.
cannot be removed unless it is torn off.
4-9. Bellows Assembly
Replacement
Fig. 39
Fig. 40
Fig. 41
Fig. 42
Fig. 43
Click on the first or last page to see other WP-620N service manuals if exist.