Read LG F1256LD / F1256LD1 / F1256MDP / F1256MDP1 / F1256NDP / F1256NDP1 Service Manual online
14
If you press the [Start/Pause] button when an error in displayed, any error except S/W ERROR will
disappear and the machine will change into pause status.
In case of
d
e, d
e, d
e, if the error is not resolved within 15 sec. In case of other errors, if the
error is not resolved within 4 min. Power will be turned off automatically and the error only will be
blinked. But in the case of
blinked. But in the case of
d
e, power will not be turned off.
7-4.ERROR DISPLAY.
ERROR SYMPTOM
C
CA
AU
US
SE
E
1
WATER INLET
Water has not reached to the pre-set level within
ERROR
4 min. since inlet valve operated, or water has not
reached to the normal level within 25 min.
2
IMBALANCE
The appliance is tilted.
ERROR
Laundry is gathered to one side.
Non distributable things are put into the drum.
Non distributable things are put into the drum.
3
DRAIN ERROR
Water has not drained enough within 8 min.
4
OVERFLOW
Water is automatically being pumped out because too much
ERROR
water is in the tub.
5
SENSOR PRESSURE
The sensor pressure switch is out of order.
S/W ERROR
6
DOOR OPEN
The
~Start/Pause₩button is pressed with the door open.
ERROR
The door switch is out of order.
7
HEATING
The thermistor is out of order.
ERROR
8
CURRENT
ERROR
PWB ASSEMBLY (Main) is out of order
Replace the PWB assembly (Main)
Winding in the MOTOR is short-circuited.
Replace the MOTOR
The Connector (3-pin, male, white) in the wire harness is not
connected to the Connector (3-pin, female, white) of MOTOR.
connected to the Connector (3-pin, female, white) of MOTOR.
Reconnect or repair the connector
9
The electric contact between the connectors
~3-pin, male, white in
the wire harness and 6-pin, female, white in the PWB ASSEMBLY
(Main)
(Main)
₩is bad or unstable.
Reconnect or repair the contact in the connector
The wire harness between the MOTOR and PWB ASSEMBLY
(Main) is cut (open circuited).
The hall sensor is out of order/defective.
(Main) is cut (open circuited).
The hall sensor is out of order/defective.
10
The washer experienced a power failure.
LOCK
ERROR
POWER
FAILURE
Click on the first or last page to see other F1256LD / F1256LD1 / F1256MDP / F1256MDP1 / F1256NDP / F1256NDP1 service manuals if exist.