Read LG 42PG6900-ZF (CHASSIS:PD84A) Service Manual online
SET Assembly Adjustment Method
Caution: Each PCB assembly must be checked by check JIG set.
(Because power PCB Assembly damages to PDP
Module, especially be careful)
Module, especially be careful)
6. 50” POWER PCB Ass’y Voltage
Adjustment
(Va, Vs Voltage Adjustment)
6-1. Model Name :
50PG6900,50PG6910
6-2. Adjustment Method
(1) Va Adjustment
1) After receiving 100% Full White Pattern, HEAT RUN.
2) Connect + terminal of D. M..M. to Va pin of P811, connect -
2) Connect + terminal of D. M..M. to Va pin of P811, connect -
terminal to GND pin of P811.
3) After turning VR901,voltage of D.M.M adjustment as same
as Va voltage which on label of panel right/top (deviation;
±0.5V)
±0.5V)
(2) Vs Adjustment
1) Input signal : RF noise signal
2) Connect + terminal of D. M..M. to Vs pin of P811, connect -
2) Connect + terminal of D. M..M. to Vs pin of P811, connect -
terminal to GND pin of P811.
3) After turning VR 951, voltage of D.M.M adjustment as same
as Vs voltage which on label of panel right/top (deviation ;
±0.5V)
±0.5V)
7. 42” POWER PCB Ass’y Voltage
Adjustment
(Va, Vs Voltage Adjustment)
7-1. Model Name:
42PG6900,42PG6910
7-2. Adjustment Method
(1) Va Adjustment
1) After receiving 100% Full White Pattern, HEAT RUN.
2) Connect + terminal of D. M..M. to Va pin of P811, connect -
2) Connect + terminal of D. M..M. to Va pin of P811, connect -
terminal to GND pin of P811.
3) After turning VR901,voltage of D.M.M adjustment as same
as Va voltage which on label of panel right/top (deviation;
±0.5V)
±0.5V)
(2) Vs Adjustment
1) Input signal : RF noise signal
2) Connect + terminal of D. M..M. to Vs pin of P811, connect -
2) Connect + terminal of D. M..M. to Vs pin of P811, connect -
terminal to GND pin of P811.
3) After turning VR 951, voltage of D.M.M adjustment as same
as Vs voltage which on label of panel right/top (deviation ;
±0.5V)
±0.5V)
8. EDID(The Extended Display
Identification Data) / DDC
(Display Data Channel) Download
(Display Data Channel) Download
8-1. Required Test Equipment
(1) Adjusting PC with S/W for writing EDID Data.(S/W: EDID
TESTER Ver.2.5)
(2) A Jig for EDID Download
(3) Cable : Serial(9Pin or USB) to D-sub 15Pin cable, D-sub
(3) Cable : Serial(9Pin or USB) to D-sub 15Pin cable, D-sub
15Pin cable, DVI to HDMI cable.
8-2. Setting of Device
- 8 -
<Fig. 3> 50inch Power PCB Assy Voltage adjustment
<Fig. 4> 42inch Power PCB Assy Voltage adjustment
<Fig. 5> Connection Diagram of DDC download
Click on the first or last page to see other 42PG6900-ZF (CHASSIS:PD84A) service manuals if exist.