Read JBL GTO 5.0c MKII User Guide / Operation Manual online
02
Trim Ring
Car Door
Grille Screen
Figure 2a.
Grille mounting
Typical installation of
the GTO5.0cMKII
woofers with grilles
as shown in Figure 2a.
the GTO5.0cMKII
woofers with grilles
as shown in Figure 2a.
Tweeter Output Level
The GTO4 is a very efficient tweeter. If
there is a need to lower the tweeter out-
put level, a pair of 4 ohm / 5 watt resistors
can be connected in series with the
GTO4 as shown in Figure 3.
To avoid short circuits, make sure that
heat-shrink tubing or electrical tape is
used to cover all exposed wiring.
The in-line crossover acts as a high-pass
filter as well as a protection device that
keeps the tweeter from being over-exert-
ed by low frequencies that it was not
designed to reproduce. Under normal cir-
cumstances this crossover should not be
bypassed or removed for any reason.
Bypass the installed capacitor only when
using an outboard active crossover or a
custom-built passive crossover set above
5kHz.
there is a need to lower the tweeter out-
put level, a pair of 4 ohm / 5 watt resistors
can be connected in series with the
GTO4 as shown in Figure 3.
To avoid short circuits, make sure that
heat-shrink tubing or electrical tape is
used to cover all exposed wiring.
The in-line crossover acts as a high-pass
filter as well as a protection device that
keeps the tweeter from being over-exert-
ed by low frequencies that it was not
designed to reproduce. Under normal cir-
cumstances this crossover should not be
bypassed or removed for any reason.
Bypass the installed capacitor only when
using an outboard active crossover or a
custom-built passive crossover set above
5kHz.
IN-LINE CROSSOVER
(mylar capacitor)
(mylar capacitor)
4 ohms /
5 watt (min)
resistor
(sold separately)
5 watt (min)
resistor
(sold separately)
cut wire here
after capacitor
after capacitor
Figure 3
Click on the first or last page to see other GTO 5.0c MKII service manuals if exist.