Read JBL GTO-3EZ Service Manual online
CONNECTIONS
IMPORTANT: Disconnect the vehicle’s negative (–) battery terminal before beginning the installation.
If you have not already done so, remove the two end caps that cover the amplifier’s connectors as explained in
Mounting the Amplifier, above. This will provide easier access to all of the amplifier’s connectors.
Mounting the Amplifier, above. This will provide easier access to all of the amplifier’s connectors.
AUTO TURN-ON SWITCH
No remote turn-on connection is necessary because GTO amplifiers include signal-sensing turn-on, which will turn
the amplifier on when it receives an audio signal at any of its input connectors. The amplifier will automatically turn off
approximately five minutes after the input signal ceases.
the amplifier on when it receives an audio signal at any of its input connectors. The amplifier will automatically turn off
approximately five minutes after the input signal ceases.
If your audio system’s source unit includes a remote turn-on wire and you would prefer to use it, the amplifier
will sense that you’ve used a remote turn-on wire and that connection will override the signal-sensing turn-on. If
necessary, you can defeat the signal-sensing turn-on circuit by moving the Auto Turn-On switch to the “Off” position.
will sense that you’ve used a remote turn-on wire and that connection will override the signal-sensing turn-on. If
necessary, you can defeat the signal-sensing turn-on circuit by moving the Auto Turn-On switch to the “Off” position.
BASS BOOST
The Bass Boost control provides up to 12dB of bass boost at 45Hz. Set this control according to your personal taste,
but be careful not to set the control at a high enough level to cause audible distortion or bottoming of your subwoofer.
but be careful not to set the control at a high enough level to cause audible distortion or bottoming of your subwoofer.
POWER/PROTECTION LED
Power/
Protection
LED
The GTO amplifier Power/Protection LED’s color indicates the amplifier’s operational status:
LED is orange: Normal operation (power is on)
LED is off: Amplifier is in standby mode
LED is red: Amplifier is in protect mode
If the amplifier is in the protect mode (the LED is red), see Troubleshooting, below.
GTO-3EZ
7
Click on the first or last page to see other GTO-3EZ service manuals if exist.