BP 600.1 (serv.man2) - JBL Car Audio Service Manual (repair manual). Page 4

Controls and Connections

Controls and Connections

Mounting the Amplifier

1. It allows left and right input channels to be 

    connected to the amplifier using RCA plugs.

 

    

2. Speaker Output Connector - Connect speaker

    wiring to these connectors. See wiring instruc-

    tions on page 4 for more information.

3. Fuse - Two 30 Amp ATC type Fuses.

The JBL BP Series amplifiers can be mounted in virtually any location inside the vehicle.
However, make sure to keep the amplifier away from heater vents or ducts.

1. At the chosen site, use the amplifier as a mounting template and mark the locations of the 
    four mounting holes.

2. Drill a small pilot hole at each marked location.

3. Mount the amplifier and securely tighten the mounting screws.

4. Power Connection for 12V+, GND and REM 
    connections for power wires. See wiring instruc-
    tions on page 4 for more information.

5. Input-Level Control - Adjusts input sensitivity
    for pre-amp level and speaker level inputs.

6. The electronic crossover is a 12dB/oct.
    Low pass filter which can be Set at any frequency 
    between 32Hz and 320Hz.

7. The bass boost control will provide up to 6dB of boost
    at 50Hz.

8. It allows left and right input channels such as high level 
    speaker output signals to be the ampifier.

1 Channel Automotive Amplifier

3

BP-600.1

FUSE 30Ax2

-       +        -        +

SPEAKER OUTPUTS

+BATT

REM

GND

POWER

+   R   -     -   L   +

+   R   -     -   L   +

HIGH LEVEL

HIGH LEVEL

INPUT
LEVEL

4V  250mV

32Hz  320Hz

0dB  +6dB

 LPF
FREQ

 BASS
BOOST

R

R

L

L

FRONT INPUTS

REAR   INPUTS

.

.

.

.

.

.

BP600.1

8

1

5

6

7

2

3

4