SPOT (serv.man2) - JBL Audio EMC - CB Certificate (repair manual). Page 52

Read JBL SPOT (serv.man2) EMC - CB Certificate online

 
 
 
 
Page 51 of 58 
 
Report No.: 
11008507 001 
National Differences 
Clause 
Requirement − Test 
Result – Remark 
Verdict 
 
Canadian National Differences according to CB Bulletin No. 110A, June 2006 
3.4.11 
For computer room applications, equipment with 
battery systems capable of supplying 750 VA for 
five minutes are required to have a battery 
disconnect means that may be connected to the 
computer room remote power-off circuit. 
No battery. 
N/A 
4.3.12 
The maximum quantify of flammable liquid stored 
in equipment is required to comply with NFPA 30. 
No flammable liquid. 
N/A 
4.3.13 
Equipment with lasers is required to meet Code of 
Federal Regulations 21 CFR 1040 (and the 
Canadian Radiation Emitting Devices Act, REDR 
C1370). 
 
N/A 
4.7 
For computer room applications, automated 
information storage systems with combustible 
media greater than 27 cubic feet are required to 
have a provision for connection of either 
automatic sprinklers or a gaseous agent 
extinguishing system with an extended discharge. 
Not information storage 
systems.  
N/A 
4.7.3.1 
For computer room applications, enclosures with 
combustible material measuring greater than 0.9 
m² or a single dimension greater than 1.8 m are 
required to have a flame spread rating of 50 or 
less. For other applications, enclosures with the 
same dimensions require a flame spread rating of 
200 or less. 
Not information storage 
systems. 
N/A 
Annex H 
Equipment that produces ionizing radiation is 
required to comply with the Code of Federal 
Regulations, 21 CFR 1020 (and the Canadian 
Radiation Emitting Devices Act, REDR C1370). 
No ionizing radiation. 
N/A 
Other differences 
1.5.1 
Components of equipment must be suitable for 
the application, and must comply with the 
requirements of the equipment standard and the 
applicable national (Canadian and/or U.S.) 
component or material standards, as far as they 
may apply. 
The acceptance will be based on the following: 
A)  A component Certified by a Canadian or U.S. 
National Certification Body (NCB) to a 
Canadian or U.S. component standard will be 
checked for correct application and use in 
accordance with its specified rating. Where 
necessary, it will also be subject to the 
applicable tests of the equipment standard. 
B)  A component, which has a CB Test 
Certificate for compliance with a relevant IEC 
component standard, will be checked for 
correct application and use in accordance 
with its specified ratings.  Where necessary, it 
Components are approved, 
see component list 1.5.1. 
Page of 62
Display

Click on the first or last page to see other SPOT (serv.man2) service manuals if exist.