Read JBL SPARK (serv.man10) EMC - CB Certificate online
Report No.: EM201300221-6
Application No.: ZJ00028648 Page 9 of 19
Procedure of Final Test
EUT and support equipment were set up on the turntable as per the configuration with highest
emission level in the preliminary test. The Analyzer / Receiver scanned from 30MHz to
1000MHz. Emissions were scanned and measured rotating the EUT to 360 degrees, varying
cable placement and positioning the antenna 1 to 4 meters above the ground plane, in both the
vertical and the horizontal polarization, to maximize the emission reading level. Record at
least six highest emissions. Emission frequency, amplitude, antenna position, polarization
and turntable position were recorded into a computer in which correction factors were used to
calculate the emission level and compare reading to the applicable limit and only QP reading
is presented. The test data of the worst-case condition(s) was recorded.
emission level in the preliminary test. The Analyzer / Receiver scanned from 30MHz to
1000MHz. Emissions were scanned and measured rotating the EUT to 360 degrees, varying
cable placement and positioning the antenna 1 to 4 meters above the ground plane, in both the
vertical and the horizontal polarization, to maximize the emission reading level. Record at
least six highest emissions. Emission frequency, amplitude, antenna position, polarization
and turntable position were recorded into a computer in which correction factors were used to
calculate the emission level and compare reading to the applicable limit and only QP reading
is presented. The test data of the worst-case condition(s) was recorded.
Below 1GHz Set the spectrum analyzer: RBW =100KHz VBW >= RBW, Span = enough to
catch the trace. Sweep = auto; Detector Function = Peak. Trace = Max,hold.
The worst case emissions were reported.
catch the trace. Sweep = auto; Detector Function = Peak. Trace = Max,hold.
The worst case emissions were reported.
4.1.3 TEST SETUP
EUT
Ground Plane
3 m
0.8 m
Cable
Test table & Turntable
1m ~ 4m
EMI
Receiver
Click on the first or last page to see other SPARK (serv.man10) service manuals if exist.