Read JBL SOUNDFLY BT EMC - CB Certificate online
Page 15 of 38
Report No. : 12-1330-0046
IEC/EN 60065
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065K
Creepage distances in accordance with 13.4
Clearance measured
according to annex E.
Pollution degree 2 was
considered.
according to annex E.
Pollution degree 2 was
considered.
P
13.2
Determination of working voltage
The apparatus was connected
to a 120 or 230V TN power
system.
to a 120 or 230V TN power
system.
P
13.3
Clearances
See below.
P
13.3.1
General
(see appended table 13)
P
13.3.2
Circuits conductively connected to the mains comply
with table 8 and, where applicable, table 9 ............. :
with table 8 and, where applicable, table 9 ............. :
(see appended table 13)
P
13.3.3
Circuits not conductively connected to the mains
comply with table 10
comply with table 10
Accessible parts circuits
verified by short-circuit tests
according to 4.3.1.
verified by short-circuit tests
according to 4.3.1.
P
13.3.4
Measurement of transient voltages
Normal transient voltage 2500
V considered (overvoltage
category II for primary circuits).
V considered (overvoltage
category II for primary circuits).
P
13.4
Creepage distances
(see appended table 13)
P
Creepage distances greater than table 11 minimum
values
values
Considered.
P
13.5
Printed boards
N/A
13.5.1
Clearances and creepage distances between
conductors on printed circuit boards, one of which
may be conductively connected to the mains, as in
fig. 10
conductors on printed circuit boards, one of which
may be conductively connected to the mains, as in
fig. 10
N/A
13.5.2
Type B coated printed circuit boards complying with
IEC 60664‑ 3 (basic insulation only)
IEC 60664‑ 3 (basic insulation only)
N/A
13.6
Conductive parts along uncemented joints
clearances and creepage distances comply with
13.3 and 13.4
clearances and creepage distances comply with
13.3 and 13.4
N/A
Conductive parts along reliably cemented joints
comply with 8.8
comply with 8.8
N/A
Temperature cycle test and dielectric strength test
N/A
500V test for transformers, magnetic coupler and
similar devices, if insulation is relied upon for safety
similar devices, if insulation is relied upon for safety
N/A
13.7
Enclosed, enveloped or hermetically sealed parts
not conductively connected to the mains, clearances
and creepage distances as in table 12
not conductively connected to the mains, clearances
and creepage distances as in table 12
N/A
13.8
Parts filled with insulating compound, meeting the
requirements of 8.8
requirements of 8.8
N/A
14
Components
P
Click on the first or last page to see other SOUNDFLY BT service manuals if exist.