SCS 135S Sub (serv.man2) - JBL Audio Service Manual (repair manual). Page 4

LFE Input: Connect to LFE/Subwoofer

Output on rear panel of DCR600 receiver
using the single-lead RCA cable with brown
connectors.

LED: Lights green when a low-frequency

signal is present and the subwoofer is playing.
Lights red when no low-frequency audio signal
is present to indicate that the subwoofer is
plugged in, powered on and in the Standby
mode.

Power Switch: Turn the power switch to

the “

•

” (dot) position to power the unit on. The

SUB135S  subwoofer will automatically turn
itself on and go into Standby (Sleep) mode
when left in the On position. When your
DCR600 is off, or is not sending program materi-
al to the subwoofer, the subwoofer will be in
Standby mode. When the subwoofer senses an
audio signal, it will automatically turn itself on.
If the subwoofer does not sense a signal after
approximately twenty minutes, it will automati-
cally go into Standby mode. If you will be away
from home for an extended period of time, or if

the subwoofer will not be used, turn this switch
off to conserve electricity and for safety.

AC Power Cord: Plug the power cord into

an unswitched outlet.

LFE

GREEN: ON
RED: STAND-BY

RISK OF ELECTRIC SHOCK

DO NOT OPEN

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, 

DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE."

"AVERTISSEMENT: POUR PR VENIR LES RISQUES D’INCENDIE OU 
DE CHOC  LECTRIQUE,  VITER D’EXPOSER CET APPAREIL A LA 
PLUIE OU A L’HUMIDIT .

 "

FOR CONTINUED 

PROTECTION AGAINST RISK 
OR FIRE, REPLACE ONLY WITH 
SAME TYPE 2.5A, 250 VOLT 

"AVERTISSEMENT: UTILISEZ UN 
FUSIBLE DE RECHANGE DE MEME 
TYPE 2.5A, 250V"

NRTL/C

CSA 22-2 No.1

UL 1492

AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

POWER

T1.25A/250V

TYPE T

200 Watts

JBL, Incorporated

3