Read JBL ON BEAT XTREME Service Manual online
9: Gently pull out the cable from the PCB by heating all the soldered joints at the same time, until all
connector pins are loose. We recommend using a flat 17mm soldering iron tip.
10: Re-mount connector tight to new PCB. 11: Resolder connector.
Re-assemble the dock arm:
A: Re-mount the iPod jack rubber
B: Mount the iPod PCB
C: Slide back the iPod support
Perform steps 6-5-4-3-2-1 from the disassembly procedure (see above).
Make sure the unit works after assembling by testing with an iPhone.
Model
Serial number
Status
Action
JBL OnBeat Xtreme
All
-
Replace iPod PCB
JBL
OnBeat Xtreme service manual
Page 31 of 33
Click on the first or last page to see other ON BEAT XTREME service manuals if exist.