Read JBL DUET III EMC - CB Certificate online
- Page 12 of 51 -
www.nemko.com
Report No. 116366
TRF No.:IECEN60950_1B
IEC 60950-1 / EN 60950-1
Clause
Requirement – Test
Result – Remark
Verdict
2.3.3
Separation from hazardous voltages
No TNV circuits in the
equipment.
equipment.
N/A
Insulation
employed.............................................:
—
2.3.4
Connection of TNV circuits to other circuits
No TNV circuits in the
equipment.
equipment.
N/A
Insulation
employed.............................................:
—
2.3.5
Test for operating voltages generated externally
No TNV circuits in the
equipment.
equipment.
N/A
2.4
Limited current circuits
—
2.4.1
General requirements
No limited current circuits.
N/A
2.4.2 Limit
values
—
Frequency
(Hz)....................................................:
—
Measured
current (mA) .......................................:
—
Measured
voltage (V) ..........................................:
—
Measured capacitance (
μF).................................:
—
2.4.3
Connection of limited current circuits to other
circuits
circuits
—
2.5
Limited power sources
—
Inherently limited output
Class III equipment powered by
Limited Power Source adaptor
certified by IEC 60950-1.
Therefore all outputs are
considered to be limited power.
(refer to summary of testing)
Limited Power Source adaptor
certified by IEC 60950-1.
Therefore all outputs are
considered to be limited power.
(refer to summary of testing)
N/A
Impedance limited output
N/A
Overcurrent protective device limited output
N/A
Regulating network limited output under normal
operating and single fault condition
operating and single fault condition
N/A
Regulating network limited output under normal
operating conditions and overcurrent protective
device limited output under single fault condition
operating conditions and overcurrent protective
device limited output under single fault condition
N/A
Output voltage (V), output current (A), apparent
power (VA)......................................................... :
power (VA)......................................................... :
—
Current rating of overcurrent protective device (A)
—
2.6
Provisions for earthing and bonding
—
Click on the first or last page to see other DUET III service manuals if exist.