Read JBL DSC 1000 EMC - CB Certificate online
Page 23 of 53
Report No: JSH0406745-001.
IEC 60065
Clause
Requirement - Test
Result - Remark
Verdict
6.1
(Cont)
The amount of ionizing radiation is regulated by
European Council Directive 96/29/Euratom of 13
May 1996. This directive requires that at any
point 10 cm from the outer surface of the
apparatus, the dose-rate shall not exceed
1µSv/h (0,1 mR/h) taking account of the
background level.
European Council Directive 96/29/Euratom of 13
May 1996. This directive requires that at any
point 10 cm from the outer surface of the
apparatus, the dose-rate shall not exceed
1µSv/h (0,1 mR/h) taking account of the
background level.
Moreover, the measurement shall be made under
fault conditions causing an increase of the high-
voltage, provided an intelligible picture is
maintained for 1 h, at the end of which the
measurement is made.
A picture is considered to be intelligible if the
following conditions are met:
- a scanning amplitude of at least 70 % of the
usable screen width;
- a minimum luminance of 50 cd/m² with locked
blank raster provided by a test generator;
- a horizontal resolution corresponding to at least
1,5 MHz in the centre, with a similar vertical
degradation;
- not more than one flashover per 5 min.
fault conditions causing an increase of the high-
voltage, provided an intelligible picture is
maintained for 1 h, at the end of which the
measurement is made.
A picture is considered to be intelligible if the
following conditions are met:
- a scanning amplitude of at least 70 % of the
usable screen width;
- a minimum luminance of 50 cd/m² with locked
blank raster provided by a test generator;
- a horizontal resolution corresponding to at least
1,5 MHz in the centre, with a similar vertical
degradation;
- not more than one flashover per 5 min.
Noted
13.3.1
Delete note 4.
Noted
14
Delete note 4 and note 5.
Noted
15.1.1
Delete note 1 and note 2.
Noted
15.2
Delete note 2.
Noted
16.1
Delete note 1.
Noted
16.2
Delete the note.
Noted
20
Delete note 2.
Noted
Annex B
Replace note 1 by:
In the CENELEC countries listed in IEC 62151,
special national conditions apply.
In the CENELEC countries listed in IEC 62151,
special national conditions apply.
Noted
Annex G
Delete the note.
Noted
Annex J.2
Delete the notes of Table J.1
Noted
Annex N
Add after the introduction:
For ROUTINE TEST reference is made to EN
50333
For ROUTINE TEST reference is made to EN
50333
.
Noted
Click on the first or last page to see other DSC 1000 service manuals if exist.