CINEMA SOUND 3 (serv.man3) - JBL Audio EMC - CB Certificate (repair manual). Page 9

 

                                                                            Page 8 of 64                   Report No. JSH006110064-001 

 

IEC/EN 60065 

Clause 

Requirement – Test 

Result - Remark 

Verdict 

 

TRF No:  IEC/EN 60065H 

 

       TRF originator Intertek ETL SEMKO SH 

 

 

9 

ELECTRIC SHOCK HAZARD UNDER NORMAL OPERATING CONDITIONS 

 

9.1 

Testing on the outside 

 

9.1.1 

For voltages >1000 V ac or >1500 V dc complies 
with clause 13.3.1 for basic insulation  

No such High voltage 

N/A 

9.1.1.1 

Touch current measured from terminal devices 
using the network in annex D ................................. :

U1= 11.3Vp 

U2= 0.12Vp 

P 

 

Discharge not exceeding 45 μC 1 

μC P 

 

 

Energy of discharge not exceeding 350 mJ 

No voltage exceeding 15kV 

N/A 

9.1.1.2 

Test with test finger and test probe 

 

P 

9.1.2 

No hazardous live shafts of knobs, handles or 
levers 

 P 

9.1.3 

Ventilation holes and other holes tested by means 
of 4 mm x 100 mm test pin 

Holes with 3.7mm x 3.7 mm 

P 

9.1.4 

Terminal devices tested with 1 mm x 20 mm test 
pin (10 N); test probe D of IEC 61032 

         

 P 

 

 

Terminal devices tested with 1 mm x 100 mm 
straight wire (1 N); test probe D of IEC 61032 

         

 P 

9.1.5 

Pre-set controls tested with 2.5 mm x 100 mm test 
pin (10 N); test probe C of IEC 61032 

         

 N/A 

9.1.6 

No shock hazard due to stored charge on 
withdrawal of the mains plug; voltage (V) after 2 s  :

9.9V P 

 

If C is not greater than 0,1 μF no test needed 

 

N/A 

9.1.7 

Enclosure sufficiently resistant to external force 

 P 

 

Test probe 11 of IEC 61032 for 10 s (50 N) 

 P 

 

Test hook of fig. 4 for 10 s (20 N) 

 

P 

 

30 mm diameter test tool for 5 s (100 or 250 N) .... : 100N P 

9.2 

No hazard after removing a cover by hand 

Can not be removed by hand 

P 

 
 

10 INSULATION 

REQUIREMENTS 

 

10.1 

Insulation resistance (MΩ) at least 2 MΩ min. after 
surge test for basic and 4 MΩ min. for reinforced 
insulation ................................................................. :

(See appended table) 

P 

10.2 Humidity 

treatment 48 h or 120 h ........................... : 48h, 30℃, 93%R.H. 

P 

10.3 

Insulation resistance and dielectric strength 

(See appended table) 

P