Read Harman Kardon SoundSticks II (serv.man8) User Guide / Operation Manual online
Cycle 1
150 lpi
11-06-03 SoundStick_II_set-up_guide_04.qxd
K
TRIM
FOLD
TRIM
R
L
Step 1. Place individual
SoundSticks II (satellites) beside
monitor/computer.
SoundSticks II (satellites) beside
monitor/computer.
Step 2. Place subwoofer as
desired, but placement under
your desk will provide optimal
performance.
desired, but placement under
your desk will provide optimal
performance.
Step 3. Connect satellites to
subwoofer.
subwoofer.
Symptom
No sound from SoundSticks II
speaker system.
speaker system.
Possible problem
No power to subwoofer.
Power adapter plug not inserted
correctly.
correctly.
No volume or low volume.
Solution
Ensure power supply is connected to live power source and properly
connected to subwoofer. Please note: When subwoofer is powered,
a green power LED should illuminate.
connected to subwoofer. Please note: When subwoofer is powered,
a green power LED should illuminate.
Place plug with arrow symbol facing UP into the subwoofer.
Touch the volume “Up” (+) pad on the volume control satellite to
un-mute and/or increase the system volume level.
un-mute and/or increase the system volume level.
Note: touching the volume “Down” (-) pad lowers the system volume.
Touching both (+) and (-) volume control pads at the same time will
mute the system.
Touching both (+) and (-) volume control pads at the same time will
mute the system.
Troubleshooting
Sound Specifications*
System
Frequency range: 44Hz–20kHz
Power consumption: 4 W idle, 65 W maximum
Power consumption: 4 W idle, 65 W maximum
Subwoofer
Transducer: (1) 6-inch woofer
Amplifier output power: 20 Wrms
Dimensions: 9.15" (23.24 cm) diam.
Amplifier output power: 20 Wrms
Dimensions: 9.15" (23.24 cm) diam.
x 10.16" (25.81 cm)
Weight: 4.93 pounds = 2.24 kg
Satellite
Transducers: (4) 1-inch full range per channel
Amplifier output power: 10 Wrms per channel
Dimensions: 2" (5.08 cm) diam. x 10" (25.4 cm)
Weight: 1.47 pounds = .67 kg
Amplifier output power: 10 Wrms per channel
Dimensions: 2" (5.08 cm) diam. x 10" (25.4 cm)
Weight: 1.47 pounds = .67 kg
SoundSticks II
Easy Setup Guide
If you have any questions, or need further assistance, please call 1-877-266-6202 or visit www.harman-multimedia.com.
*These specifications are subject to change without notice.
6
*These specifications are subject to change without notice.
6
Step 5. Plug power cord into
power adapter.
power adapter.
Step 4. Plug power adapter
into subwoofer.
into subwoofer.
Step 6. Plug power cord into
wall receptacle.
wall receptacle.
Step 7. Insert SoundSticks II
input cable into the computer or
other audio device.
input cable into the computer or
other audio device.
Symptom
No sound from subwoofer,
only satellites.
only satellites.
No sound from satellites,
only subwoofer.
only subwoofer.
High frequencies sound dull.
Possible problem
Subwoofer volume control set
at minimum.
at minimum.
Satellites not connected
to subwoofer.
to subwoofer.
Satellites not positioned properly.
Solution
Rotate subwoofer volume control clockwise until relative volume level
is appropriate.
is appropriate.
Check connection of satellites to subwoofer.
Position and tilt (angle) loudspeakers towards listener. The sound from
the satellites is very directional due to the 4-element linear array design
the satellites is very directional due to the 4-element linear array design
.
7
www.harman-multimedia.com
This product is intended to be supplied by a Listed Direct Plug-in Power Unit marked ‘Class 2 and Output rated 16 Vdc minimum 1.5A.
Click on the first or last page to see other SoundSticks II (serv.man8) service manuals if exist.