SB 35 Sabre (serv.man2) - Harman Kardon Audio EMC - CB Certificate (repair manual). Page 3

Page 3 of 41 

Report No.: ACSCBAV13005

 

 

TRF No. IEC60065K 

 
List of Attachments (including a total number of pages in each attachment):  
- 

Attachment 1: European Group Differences (15 pages) 

- 

Attachment 2: National Deviations: Australia/New Zealand, Korea, MALAYSIA, Japan (15 pages) 

- 

Attachment 3: Manufacturer’s Declaration (2 pages) 

- 

Attachment 4: Photographs (12 pages)  

- 

Attachment 5: Diagrams (4 pages) 

- 

Attachment 6: Schematics + PWB Layout (5 pages) 

1)  The sample tested complies with the requirements of the test specification. 

2)  Soundbar (SABRE SB35CNTR) and Subwoofer (SABRE SB35SUB) were evaluated respectively. 

3)  As for Power Transformer (T541) in power supply board of Subwoofer (SABRE SB35SUB), multi 

factories will produce them as alternative use. Since it was same to each other on construction and 
electrical characteristics, the difference of factory did not affect safety aspects.  
Unless otherwise specified, all tests were conducted on the following transformer as representative. 
T541:  Huizhou Sunshine Electronics Co., Ltd. / BCK-AL140 

4)  Following symbols and abbreviations are used in this test report. 

S/C= Short-Circuit 

 

O/C= Open-Circuit 

NH= No Hazard Occurred 

NFR= No Further Results existed 

NB= No breakdown                      NCD= No component damaged 
PCB= Printed Circuit Board 
* = Determined by the method specified in Note f to Table 3. 

Tests performed (name of test and test clause):
Marking durability test (5) 
Input test (5.1) 
Heating test (7.1) 
Touch current (9.1.1) 
Withdrawal of mains plug test (9.1.6) 
Humidity test (10.2) 
Insulation resistance and dielectric strength test 
(10.3) 
Fault condition test (11.1) 
Heating test under fault condition (11.2) 
Impact test (12.1.3) 
Stress relief test (12.1.5) 
Determination of operating voltage (13.2) 
Screw securement test (17.1) 
Stability test (19.1) 
Wall or ceiling mounting means test (19.6) 

Testing location:  see page 2 (Testing procedure 
and testing location) 

Summary of compliance with National Differences 
List of countries addressed: EU, AU, NZ, KR, MY, JP 

 The product fulfils the requirements of _ IEC 60065: 2001 (Seventh Edition) + A1: 2005 + A2: 2010/ 

EN 60065: 2002 (Seventh Edition) + A1: 2006  + A11: 2008 + A2: 2010 + A12: 2011_