SB 15 (serv.man4) - Harman Kardon Audio Service Manual (repair manual). Page 6

10

10

11

You can program the soundbar so it will respond to your TV remote’s Power, Mute, 
Volume Up, Volume Down and Source commands . This lets you control your whole 
home theater system with a single remote . Before beginning to program the 
soundbar, have your TV remote handy . We recommend sitting down in front of the 
soundbar . The steps will time-out, so read through the entire procedure before you 
begin . 

With the soundbar turned on, hold down the soundbar’s Power and Source 

1 . 

Selector (SRC) buttons together until all the soundbar button indicators flash . This 
enters the learning mode .

Hold down 

both buttons until 

all indicators flash

Momentarily press the soundbar’s Power button . It will turn amber .

2 . 

Momentarily 

press

Aim the TV remote at the front of the soundbar from about 300mm-900mm 

3 . 

(about 12-36 inches) away . 

TV 

Remote

300mm-900mm 

12"-36"

Hold down the TV remote's Power button for one second, then release it . Do this 

4 . 

a total of four (4) times . When the soundbar has learned the power command, 
its Power Indicator will turn blue, and the Surround Mode and Source Selector 
Indicators will flash blue .

If the Power Indicator flashes amber, the procedure failed . Repeat Steps 1 – 4 .

Follow Steps 1–4 as above, but in Steps 2 and 4, substitute the soundbar and TV 
remote’s Source Selector and Volume Up/Down buttons for the Power buttons .  

Follow Steps 1-4 as above, but in Step 2, hold down the soundbar's Power button for 
2-3 seconds . In step 4, substitute the TV remote's Mute button for its Power button .

Hold down the soundbar's Surround Mode and Volume Up buttons at the same time 
for 2-3 seconds .

harman/kardon

SB 15/230 Service Manual

Page 6 of 30