Read Harman Kardon HKTS 60 (serv.man2) Service Manual online
8
Connecting the Subwoofer to a Receiver or
Preamp/Processor With a Dedicated Subwoofer Output
Use this installation method for receivers and preamp/processors that
have a dedicated subwoofer output with low-pass filtering (also called
bass management). If the dedicated subwoofer output does not have
low-pass filtering, follow the instructions in Connecting the Subwoofer
to a Receiver or Preamp/Processor With Line Outputs, on page 9.
Use the LFE (purple) connector of the supplied combination LFE and
trigger cable to connect the HKTS200SUB’s
Line-Level LFE In Jack
to the dedicated subwoofer output (or LFE output) of your receiver or
preamp/processor.
Connect each satellite speaker and the center speaker to the
corresponding speaker terminals on your receiver or amplifier.
In your receiver or preamp/processor’s setup menu, configure it for
Subwoofer ON, and set the front left, front right, center, and surround
speakers to Small. After you have made and verified all connections,
plug the HKTS200SUB’s
AC Power Cord into an active AC outlet.
6
9
PL0004-01001
+
–
+
–
+
–
+
–
+
–
LEFT
SUB
LFE OUT
+
–
+
–
+
–
+
–
+
–
+
–
+
–
RIGHT
SURROUND
FRONT
CENTER
Left Front
Right Front
Left
Surround
Right
Surround
Center
Subwoofer
Receiver
LFE/Trigger Cable
(Purple Ends)
Surround Left
Speaker Cable
(Blue Bands)
Front Left
Speaker Cable
(White Bands)
Front Right
Speaker Cable
(Red Bands)
Center
Speaker Cable
(Green Bands)
(Green Bands)
Surround Right
Speaker Cable
(Gray Bands)
Harman Kardon
HKTS 20+30+60 Service Manual
Page 19 of 49
Click on the first or last page to see other HKTS 60 (serv.man2) service manuals if exist.