HKTS 60 (serv.man2) - Harman Kardon Audio Service Manual (repair manual). Page 17

Read Harman Kardon HKTS 60 (serv.man2) Service Manual online

6
5. If you’re not running the speaker wire through the wall, insert  
    it through the wall portion of the wall-mount bracket as  
    shown in the illustration.
6. Pass the speaker wire through the speaker portion of the 
    wall-mount as shown in the illustration.
Bring Wire In
through Here
Bring Wire Out
through Here
7. If you have not already removed the speaker’s base, do so by 
    pulling it straight off the speaker, as shown in the illustration.  
    Applying even pressure to both sides of the base will allow it 
    to slide off smoothly.
   
   CAUTION: Before making speaker connections, be sure that 
   your receiver or amplifier is turned OFF and preferably, 
   its AC cord is unplugged from the AC outlet.
Apply Pressure Evenly
to Both Sides of Base
Lift Base Straight
off Speaker
8. Connect the speaker wire to the speaker terminals as shown in 
    the illustration: 
    a) Press down on the top of the terminal to open the connection hole.
    b) Insert the wire’s bare end all the way into the hole.
    c) Release the terminal to secure the wire. 
    Insert the conductor with the colored band into the speaker’s 
    red ( + ) terminal, and insert the other conductor into the speaker’s 
    black ( – ) terminal.
IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch 
each other or the other terminal. Touching wires can cause a short 
circuit that can damage your receiver or amplifier.
+
A. Push Down on Cap
     to Open Hole
B. Insert Bare Wire
     into Open Hole
C. Release Cap
     to Secure Wire
10. Slide the speaker onto the mount’s wall section as shown in  
      the illustration. Pull any slack speaker wire back through 
      the mount's wall section.
11. Fit the metal stop plate into the recess on the bottom of the   
      mount with the pad facing the mount, and fasten it to the  
      mount using two of the supplied screws. This will prevent 
      the speaker from detaching from the bracket and will hold    
      the speaker’s position as you rotate it on the mount.
Slide Speaker
onto Wall-Mount
Stop Plate
Supplied Screws
9. Slide the speaker portion of wall-mount onto the speaker as shown in 
    the illustration. Fit the grooves on the mount onto the rails in the speaker,  
    and apply even pressure on both sides of the mount so it slides straight  
    onto the speaker.
   • Push the mount all the way onto the speaker until it snaps into place.
   • Pull any slack speaker wire back through the mount as you slide the   
      mount onto the speaker.
Fit Bracket Grooves
onto Speaker Rails
Push Down Evenly on Both Sides of Bracket
NOTE: If you’re running the speaker wire through the wall you can bring 
it out directly behind the bracket location and insert it through the 
bottom opening in the wall portion of the wall-mount, as shown in the 
illustration. This will keep the wire completely hidden from view once 
the installation is complete.
Insert Wire into
Bottom Opening
Bring Wire Out
through Here
Harman Kardon
HKTS 20+30+60 Service Manual
Page 17 of 49
Page of 49
Display

Click on the first or last page to see other HKTS 60 (serv.man2) service manuals if exist.