Read Harman Kardon HKTS 5 Service Manual online
HKTS 5
5
Mounting Options
3. Bring the speaker cable through the wall-bracket attachment plate, and mount the
attachment plate on the wall in the desired location.
Bring Speaker Cable
Through Opening
4. Thread the speaker cable through the arc-shaped opening on the top of the mounting
bracket, not the screw hole.
Cable to
Speaker
Cable from
Wall Plate
Side View
Overhead View
Bring Speaker Cable
Through Arc-Shaped
Opening
5. Attach the mounting bracket to the wall plate by inserting the tab at the top of the
attachment plate into the slot on top of the bracket and snapping the bracket onto
the attachment plate.
Insert Tab into Slot
and Snap Bracket
onto Plate
Feed Cable Through
Mount and out of
Opening
6. Fit the terminal cover onto the bracket as shown in the illustration below, then
connect the speaker leads to the terminals on the underside of the speaker.
Remember to observe the correct polarity.
Terminal Cover
Mounting Bracket
Side View
Connect Cable Leads
to Speaker Terminals
7. Fit the terminal cover into the opening on the underside of the speaker so that it is
flush against the speaker and covers the terminals. Insert the supplied long bracket
bolt up through the bottom of the bracket and terminal cover, and screw it into the
threaded insert on the underside of the speaker. The bolt should be snug but not so
tight as to prevent the speaker from pivoting on the bracket.
Fit Terminal Cover
into Recess on
Speaker Bottom
Attach Speaker
to Bracket Using
Long Bolt
You can pivot the wall-mounted speaker from side to side; however, attempting to tilt it
up or down will damage the bracket and possibly the wall, which would not be covered
by your warranty.
Wall-Mounting the Center Speaker
1. Determine the location for the speaker. If possible, position the speaker so that one
of the mounting screws (not included; use size #10) can be installed directly into a
wall stud. If that is not possible, use optional wall anchors that are rated to support
at least 25 lb (11.3kg) and are appropriate for the construction and materials of your
wall.
The customer is responsible for the proper selection and use of mounting
hardware, available through hardware stores, to wall-mount the speaker
properly and safely.
2. Bring the speaker cable through the wall-bracket attachment plate as shown, and
mount the attachment plate on the wall in the desired location.
Use Mounting Hardware Appropriate
for Wall Construction and Materials
Bring Cable Through
Opening
3. Remove the rubber pads from the foot rests on the bottom of the center speaker
and connect the speaker leads to the terminals on the underside of the speaker.
Remember to observe the correct polarity.
4. Use the supplied screws to attach the speaker to the wall-mount bracket. The screws
thread into the center foot-rest openings that were exposed when you removed the
rubber pads in the previous step.
Use Supplied Screws
to Attach Speaker to
Bracket
Thread Screws into
Center Openings
Connect
Cable
Remove Pads
Click on the first or last page to see other HKTS 5 service manuals if exist.