DPR 1005 (serv.man2) - Harman Kardon Audio User Guide / Operation Manual. Page 13

MAIN REMOTE CONTROL FUNCTIONS

* SPL Select Button: This button activates
the EzSet function to quickly and accurately
calibrate the DPR 1005’s output levels. When the
button is pressed you will then need to select
between automatic EzSet operation or using the
remote as a manual SPL meter by pressing the

⁄

/

¤

E until your choice

appears in the remote’s LCD display. Press the
Set Button

F to enter the setting, and then

follow the instructions as displayed in the LCD
display. (For complete information, see page 28.)

+ Channel Up/Down Selector: This button
has no function when the DPR is being con-
trolled, but when programmed for use with a
VCR, TV, cable box, satellite receiver or other
similar product it will change the channel up or
down. See pages 46-48 for more information on
programming the remote.

, Mute: Press this button to momentarily
silence the DPR or TV set being controlled,
depending on which device has been selected.
When the DPR remote is being programmed to
operate another device, this button is pressed with
the Input Selector button 

4 to begin the

programming process. (See page 46 for more
information on programming the remote.)

- EzSet Sensor Microphone: The sensor
microphone for the EzSet microphone is behind
these slots. When using the remote to calibrate
speaker output levels using EzSet, be sure that
you do not hold the remote in a way that covers
these slots. (See page 28 for more information
on using EzSet).

. Tone Control Button: This button controls
the tone mode settings, enabling adjustment of
the bass and treble boost/cut. You may also use
it to take the tone controls out of the signal path
completely for “flat” response. The first press of
the button displays a 

TONE I N

message in

the Lower Display Line

˜ and in the on-

screen display. To take the controls out of the
signal path press either of the 

⁄

/

¤

E until the display reads 

TONE

OUT

. To change the bass or treble settings,

press the button again until the desired option
appears in the Lower Display Line

˜ and in

the on-screen display and then press either of
the 

⁄

/

¤

E to enter the

desired boost or cut setting. See page 22 for
more information on the tone controls.

NOTE: With the press of any remote button the
Input Selector button

45 associated

with the botton pressed will briefly flash red to
confirm the transmission of the command, as
long as there is a function for that button with
the device selected.