AVR 200 (serv.man7) - Harman Kardon Audio User Guide / Operation Manual. Page 10

REAR-PANEL CONNECTIONS  9

¡ AM Antenna: Connect the AM loop anten-
na supplied with the receiver to these terminals.
If an external AM antenna is used, make con-
nections to the AM and GND terminals in accor-
dance with the instructions supplied with the
antenna.

™ FM Antenna: Connect the supplied indoor
or an optional external FM antenna to this ter-
minal.

£ Remote IR Input: If the AVR 200RDS’s
front-panel IR sensor is blocked due to cabinet
doors or other obstructions, an external IR sen-
sor may be used. Connect the output of the
sensor to this jack.

¢ Remote IR Output: This connection per-
mits the IR sensor in the receiver to serve other
remote-controlled devices. Connect this jack to
the “IR IN” jack on compatible equipment.

∞ Subwoofer Output: Connect this jack to
the line-level input of a powered subwoofer. If
an external subwoofer amplifier is used, con-
nect this jack to the subwoofer amplifier input.

§ DVD Inputs: Connect the analog audio
outputs and composite video output of a DVD
or LD player to these jacks.

¶ CD Inputs: Connect these jacks to the ana-
log output of a compact disc player or CD
changer.

• Tape Inputs: Connect these jacks to the
PLAY/OUT jacks of an audio recorder.

ª Tape Outputs: Connect these jacks to the
RECORD/INPUT jacks of an audio recorder.

‚ Video Monitor Output: Connect this jack
to the composite video input of a TV monitor or
video projector to view the output of any stan-
dard video source selected by the receiver’s
video switcher.

⁄ Speaker Terminals: Connect these termi-
nals to the appropriate speakers, following the
designations shown.

NOTE: When making connections to the Speak-
er Terminals always be certain to maintain cor-
rect polarity between the speaker’s terminals
and those on the AVR by connecting red (+) ter-
minals to red, and black (–) terminals to black.
(See page 13 for more information on speaker
polarity.)

¤ Switched AC Outlet: This outlet may be
used to power any device that you wish to have
turn on when the unit is turned on with the
System Power Control switch 2.

NOTE: The power consumption of the device
plugged into this outlet ¤ should not exceed
100 watts.

‹ AC Power Cord: Connect the AC plug to a
nonswitched AC wall output.

› Coaxial Digital Inputs: Connect the coax
digital output from a DVD player, MD Player,
HDTV receiver, LD player or CD player to these
jacks. The signal may be either a Dolby Digital
signal or a standard PCM digital source.

fi Optical Digital Input: Connect the optical
digital output from a DVD player, MD Player,
HDTV receiver, LD player or CD player to this
jack. The signal may be either a Dolby Digital
signal or a standard PCM digital source.

fl Video 2 Inputs: Connect these jacks to the
audio and video outputs of a TV Tuner, Cable TV
converter box, satellite receiver or any other
audio/video source.

‡ Video 1 Inputs: Connect these jacks to the
audio and video PLAY/OUT jacks of a VCR.

° Video 1 Outputs: Connect these jacks to
the audio and video RECORD/IN jacks of a VCR.

· 6-Channel Direct Inputs: If an external
digital audio decoder is used, connect the out-
puts of that decoder to these jacks.