ADAPT (serv.man2) - Harman Kardon Audio Service Manual (repair manual). Page 6

 Standby

To conserve electricity, the Omni 10, Omni 20, or 
Adapt will automatically enter Standby mode after 
10 minutes, if no audio is playing and no buttons 
are pressed. The Link button LED will turn amber, 
and the amplifiers will turn off. Wi-Fi, Bluetooth®, 
and Aux-in will continue to be monitored during 
Standby mode. You can wake your product up 
again by pressing the Link button, or by beginning 
to play audio to it via Wi-Fi, Bluetooth®, or Aux-in. 
If an audio signal is detected, the product will 
automatically wake up.

Note: Since the product will automatically wake up 
from Standby mode if Aux-in audio is played, you 
must pause or stop playback on your connected 
Aux-in source device to allow your Omni 10, Omni 
20, or Adapt to enter standby.

You may manually enter Standby mode by pressing 
and holding the Play/Pause button on the top 
panel of the product for 3 seconds.

Note: The speaker in a ‘Stereo pair’ which is not 
the Master will automatically enter standby when 
there is no audio playback.

  System Reset

To restore your product to factory default settings, 
press and hold the reset button for 5 seconds. All 
Wi-Fi settings, room names and groups, volume 
settings, and paired Bluetooth® devices will be 
forgotten. You can also use this method to enter 
Wi-Fi setup mode (see Setting up Wi-Fi via the 
Harman Kardon Controller app (iOS®), on page 
12, or Setting up Wi-Fi via the Harman Kardon 
Controller app (Android™), on page 20)

O

P

E

R

A

T

IN

G Y

O

U

R O

M

N

I 1

0

, O

M

N

I 2

0

, A

D

A

P

T

Omni 10

Omni 20

Adapt

Page 6 of 26