SAL2875 - Sony Digital Camera Service Manual (repair manual). Page 6

SAL2875 (2.8/28-75 SAM) (28-75mm F2.8 SAM)

2-3

Note for assembling and grease applying positions are shown.

SAL2875 (2.8/28-75 SAM) (28-75mm F2.8 SAM)

1.  Bent the tip of the zoom brush and cut off the notch.
2.  Fix the position of the zoom brush and then adjust.  (refer to 4-7-3).
3.  Install the polyester tape (black) 10mm, insulating tape, set tape A 2 pieces, zoom brush cover, brush cover, and insulating 

tape.

  Set the position of the brush cover and the zoom brush cover as instructed in the figure to install.

Zoom Brush 
Cover

Zoom Brush Cover

Zoom Brush Cover

Brush Cover

Brush Cover

Brush Cover

Set Tape A

Polyester Tape (Black) 10mm

Zoom Brush

Insulating Tape

Insulating Tape

Insulating Tape

Tip of zoom brush

Notch

Adhesive bond (B-10): J-6082-612-A

1.  Set the index mark and two cut position of the unit to the 7 o'clock position, then attach the 1st lens adjustment washer and the 

1st group assy to the unit.

2.  Set the circular hole to the index mark, then attach the 1st group assy to the unit and fix them with three screws.
3.  Set the index mark and two cut portions as shown in the figure, then attach the filter screw frame assy to the unit and fix them 

with three screws.

4.  Apply adhesive bond (B-10) to the hole of the 1st group assy in 3 locations (hole for fixing front ornament ring).

Cut portion

Oblong Hole

Circular Hole

Unit

Filter Screw Frame Assy

Front Ornament Ring

1st Group Assy

1st Washer

1st Lens Adjustment Washer

Index mark

Index mark

Index mark

Index 
mark

Apply the adhesive
bond (B-10)

Filter Screw Frame Assy
(Viewed from the objective lens side)

1st Group Assy 
(Viewed from the objective lens side)

Two cut portion

1st Washer, 1st Lens Adjustment Washer
(Viewed from the objective lens side)