MX-FN21, MX-FN22, MX-PN13 (serv.man6). MX-FN21 MX-FN22 Installation Manual - Sharp Copying Equipment Service Manual (repair manual). Page 6

Read Sharp MX-FN21 / MX-FN22 / MX-PN13 (serv.man6) Service Manual online

MX-7040N  MX-FN21/FN22 (FINISHER/SADDLE STITCH FINISHER)  20 – 6
2)
Turn the fixing nut of the caster in the arrow direction with the
wrench to loosen it.
3)
Turn the adjustment nuts of the caster in the arrow direction
with the wrench to adjust the height. (When the adjustment nut
is turned one rotation, the finisher height is changed by about
1.75mm.)
• To heighten the finisher height: Turn in direction [A].
• To lower the finisher height: Turn in direction [B].
MEMO: To adjust the height, use the four casters shown in the
figure below.
4)
Turn the adjustment nut of the caster in the arrow direction
with the wrench to adjust the tilt.
• To tilt the finisher to the right: Turn in direction [A].
• To tilt the finisher to the left: Turn in direction [B].
MEMO: To adjust the tilt, use the two casters shone in the fig-
ure below.
I.
Cable connection
1)
Insert the wire saddle (Packed items No.4) into the hole in the
upper rear cover to attach.
2)
Attach the interface cable to the wire saddle. (The figure below
shows that the cable is wound two turns and fixed.)
3)
Connect the AC cable.
[A]
[B]
[B]
[A]
[A]
[B]
[A]
[B]
1
Page of 7
Display

Click on the first or last page to see other MX-FN21 / MX-FN22 / MX-PN13 (serv.man6) service manuals if exist.