Read Sharp 32JF-77 Specification online
2
32JF-77H
Use this page to keep any special servicing information as Technical Report (Bulletin), Technical Information, etc.
If only part number changes are required, just change part number directly the part number in the Parts Listing Section.
If you need more information, please refer to the Technical Report (Bulletin).
If only part number changes are required, just change part number directly the part number in the Parts Listing Section.
If you need more information, please refer to the Technical Report (Bulletin).
SERVICE MANUAL UPDATE LOG SHEET
Part No.
Technical Report No.
Technical Bulletin No.
Technical Bulletin No.
Cause / Solution
Page No.
Application
Data /Serial No.
Data /Serial No.
3
32JF-77H
ELECTRICAL SPECIFICATIONS
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
•White Level
Set brightness control to get total picture tube cathode current of 600
µA under no signal condition.
Maximum necessary correction of each picture tube cathode current to get 8900 degrees
K-20 MPCD
screen temperature should not exceed 15% of its original value.
X=0.290 ± 0.015 Y=0.284 ± 0.015
•Power Input .................... 220V-240 Volts AC 50Hz
•Power Consumption
Normal Operation (Method IEC60107) ............ 115W
Stand-by Operation ..........................................1.5W
Stand-by Operation ..........................................1.5W
•Audio Power Output Rating (MPO) / Impedance
Internal Left Speaker ................................. 15 W, 6
Ω
Internal Right Speaker ............................... 15 W, 6
Ω
Elliptic x 2 .................................................. 18 x 4.2 cm
Tweeter x 2..................................................... 2.7 cm
Tweeter x 2..................................................... 2.7 cm
•Convergence (Maximum Misconvergence)
Static (Centre) between any two colours ... 0.03 cm
Dynamic after static equals zero
Dynamic after static equals zero
Within 32 x 17.4 cm rectangle ........... 0.13 cm
64 x 34.8 cm rectangle........................ 0.15 cm
64 x 34.8 cm rectangle........................ 0.15 cm
Everywhere else .......................................... 0.18 cm
•Focus ....................... High Bi-Potential Electrostatic
•Sweep Deflection ..................................... Magnetic
•Picture Intermediate frequency
I .................................................... 38.9MHz
•Sound Carrier Trap
I .................................................. 32.9MHz
•Adjacent Sound Carrier Trap
I .................................................. 40.9MHz
•Adjacent Picture Carrier Trap
I .................................................... 30.9MHz
•Aerial Input Impedance
VHF/UHF ................. 75 ohm Unbalanced
•Tuning Ranges ..... 45.75MHz thru 855.25 MHz
VHF: IR A - J / S1 - S41 CH (Hiperband)
UHF: I21 - I69 CH
CATV Special Channels
UHF: I21 - I69 CH
CATV Special Channels
Display
