MX-5500N, MX-6200N, MX-7000N (serv.man35). MX-FRX3 FRX3U Data security Kit-Installation Manual - Sharp Copying Equipment Peripheral (repair manual). Page 4

MX-7000N  MX-FRX3, MX-FRX3U  9 – 4

* If the fax box unit is installed, carry out the steps 3).

3)

Connect the I/F cable to the MFP PWB. Push the I/F cable into
the recessed portion of the sheet metal on the control box.
Attach the snap band to sheet metal of the control box.
*Check that the connector is not obliquely inserted.

4)

Push the control box into the main unit. Lay the finger handle.
Fix with the screws.

5)

Push into the cable to the right cabinet rear cover, and attach
it. At this time, check that the pawls are properly fitted to the
main unit.

* Reconnect the cables that have been removed in step B to the

original positions of the control box.

1)

Insert the power plug of the main unit to the power outlet.

2)

Open the front cabinet of the main unit, and turn ON the main
power switch.

3)

Turn ON the power switch on the operation panel.

1)

To enable the data security function, use the keys on the oper-
ation panel to enter the product key.
a)

Touch [PRODUCT KEY INPUT].

b)

Enter the product key with the 10-key and touch [OK] key.

2)

After completion of the product key entry,
Then, turn on the main power switch and then turn on the
power switch on the operation panel of the main unit again.
After the power switches are turned on, message "Please
wait.  may appear and encryption and deletion of data may
take several minutes before the main unit starts.