Read Sharp LL-173C Service Manual online
LL-173C
CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
2 – 1
CHAPTER 2. CONNECTION, ADJUSTMENT, OPERATION, AND FUNCTIONS
1. CONNECTING THE MONITOR AND TURNING THE MONITOR ON AND OFF
Caution:
• When connecting, ensure that both the monitor and computer are
switched off.
• Be careful not to over bend the cable or add extension cords as this
could lead to a malfunction.
1-1. CONNECTING THE MONITOR TO A COMPUTER
Connect the supplied analog signal cable to the analog RGB output ter-
minal of the computer.
Paying attention to connector direction, firmly insert the signal cable
vertically into the connector, and then tighten the screws at both sides.
If connecting to a D-sub 15 pin 2 row Apple Power Macintosh, attach a
Macintosh conversion adapter (commercially available) to the analog
Macintosh conversion adapter (commercially available) to the analog
signal cable.
Note: If connecting to the Sun Ultra series, a conversion adapter (com-
mercially available) may be required.
1-2. CONNECTING THE MONITOR TO A POWER SOURCE
1-3. TURNING THE POWER ON
1. Press the monitor's power button (
q
).
2. Turn on the computer.
When a signal is input from the computer, the power LED lights up
green, and the screen is displayed. (After power is turned on, it may
take a little time until the screen is displayed.)
Note:
• When using the monitor for the first time or after having changed
the system settings during use, perform an automatic screen
adjustment.
adjustment.
• Depending on the type of computer or OS, you may need to install
the monitor set-up information on your system.
• When connecting to a notebook computer, if the notebook com-
puter's screen is set to display at the same time, the MS-DOS
screen may not display properly. In this case, change the setting to
display only the LCD monitor.
1-4. TURNING THE POWER OFF
1. Turn the computer off.
2. Press the monitor's power button (
q
).
The power LED will disappear.
If the monitor is not going to be used for a long period of time, be
sure to unplug it from the AC outlet.
2. INSTALLING/REMOVING THE BASE
Caution: Be careful not to touch the LCD panel when you install/remove
the base. The LCD panel used in this monitor is made of glass.
Pressure from hands on the LCD panel could cause damage.
Analog signal cable
(supplied)
Analog RGB terminal
(Mini D-sub 15 pin, 3 rows)
(Mini D-sub 15 pin, 3 rows)
Computer
Macintosh conversion adapter
Power Macintosh
AC outlet
Power cord (supplied)
Power terminal
Turn on the
computer
powersupply.
computer
powersupply.
ON
Press power button.
OFF
Turn the
computer off.
computer off.
Press power button.
Click on the first or last page to see other LL-173C service manuals if exist.