Read Panasonic PT-DZ13KU / PT-DZ13KE / PT-DZ13KT / PT-DS12KU / PT-DS12KE / PT-DW11KU / PT-DW11KE / PT-DZ10KU / PT-DZ10KE (serv.man2) Service Manual online
ET-LAD310AW (2 pcs)
(for portrait mode)
ET‑LAD320PW (2 pcs)
PT-DZ13KE
PT-DZ13KT
PT-DS12KU
PT-DS12KE
PT-DW11KU
PT-DW11KE
PT-DZ10KU
PT-DZ10KE
Use lead free solder in servicing from the standpoint of antipollution for the global environment.
Notes:
・ Be precautious about lead free solder. Sn-Ag-Cu (tin, silver and copper) will tend to splash when heated too high (approx. 600°C or higher).
・ Use lead free solder for the P.C.Board (specified on it as “PbF”) which uses lead free solder. (When you unavoidably use lead solder, use lead
・ solder after removing lead free solder. Or be sure to heat the lead free solder until it melts completely, before applying lead solder.)
For the P.C.Board which applies lead free solder, the symbol as shown in the figure below is printed or stamped on the surface
or the back of P.C.Board.
diagram. It is essential that these critical parts should be replaced with manufacturer’s specified parts to prevent shock, fire, or other
hazards. Do not modify the original design without permission of PANASONIC SOLUTIONS COMPANY.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with
the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely
to cause harmful interference in which case the user will be required to correct the interference at his own expense.
It dose not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service
or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.
(Refer to “PROJECTOR SETUP menu” in Operating Instructions.)
Failure to observe this may cause malfunctions. Never use this projector at an altitude of 2,700m or higher.
Using this projector at high altitude, consult your dealer or Authorized Service Center about preparations.
Replace only with the same of equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
・When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts.
・Do not transport the projector with the adjustable feet extended.
・Near the exhaust of an air conditioner: Depending on the conditions of use, the screen may fluctuate in rare cases
・Places with sharp temperature fluctuations such as near lights (studio lamps): Doing so may shorten the life
・Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
・Places where there is high-power laser equipment: Directing a laser beam onto the lens surface causes damage
the period just after switching on the power. Wait at least 30 minutes with the image projected before adjusting
・Make sure to set [HIGH ALTITUDE MODE] to [ON] when using the projector at elevations between 1 400 m (4 593')
・Do not use the projector tilted to the right or left.
・When installing and using the projector at an angle that exceeds 30° vertically, set [COOLING CONDITION].
・When using the portrait mode only lamp unit, install the projector with the terminals surface facing down.