Read Sony SLV-SE740B / SLV-SE740D / SLV-SE740E / SLV-SE740G / SLV-SE740I / SLV-SE740N / SLV-SE747E / SLV-SE840B / SLV-SE840D / SLV-SE840E / SLV-SE840G / SLV-SE840N / SLV-SX740D / SLV-SX740E / SLV-SX740N Service Manual online
5-11
(4) Envelope Check
1) Make recordings on T-120 (E-120) and T-160 (E-180) tape.
Make sure the playback output envelope meets the specification as shown in Fig. 5-15.
2) Play back a self recorded tape (recording made on the unit using with T-120 (E-120).
The video envelope should meet the specification as shown in Fig. 5-15.
In SP mode, (A) should equal (B).
If the head gap is wide, upper cylinder should be checked.
Make sure the playback output envelope meets the specification as shown in Fig. 5-15.
2) Play back a self recorded tape (recording made on the unit using with T-120 (E-120).
The video envelope should meet the specification as shown in Fig. 5-15.
In SP mode, (A) should equal (B).
If the head gap is wide, upper cylinder should be checked.
Fig. 5-15 Envelope Input and Output Level
(5) Tape Wrinkle Check
1) Run the T-160 (E-180) tape in the playback, FPS, RPS and Pause modes and observe tape wrinkle at each guide.
2) If excessive tape wrinkle is observed, perform the following adjustments in Playback mode :
2) If excessive tape wrinkle is observed, perform the following adjustments in Playback mode :
◆ Tape wrinkle at the guide roller S, T section : Linearity adjustment.
◆ Tape wrinkle at tape guide flange : ACE head assembly coarse adjustment.
◆ Tape wrinkle at tape guide flange : ACE head assembly coarse adjustment.
5-4-3 Reel Torque
1) The rotation of the capstan motor causes the holder clutch ass’y to rotate through the belt pulley.
2) The spring wrap PLAY/REV of holder clutch ass’y drives the disk reel S, T through gear idler by rotation of gear center ass’y.
3) Brake is operated by slider cam at FF/REW mode.
4) Transportation of accurate driving force is done by gears. (Gear Center Ass’y)
2) The spring wrap PLAY/REV of holder clutch ass’y drives the disk reel S, T through gear idler by rotation of gear center ass’y.
3) Brake is operated by slider cam at FF/REW mode.
4) Transportation of accurate driving force is done by gears. (Gear Center Ass’y)
Note:
If the spec. does not meet the followings specifications, replace the holder clutch ass’y and then recheck.
< Table 5-2 >
MODE
TORQUE g/cm
GAUGE
PB
42
±
11
Cassette Torquemeter
RPS
145
±
30
Cassette Torquemeter
A
B
Click on the first or last page to see other SLV-SE740B / SLV-SE740D / SLV-SE740E / SLV-SE740G / SLV-SE740I / SLV-SE740N / SLV-SE747E / SLV-SE840B / SLV-SE840D / SLV-SE840E / SLV-SE840G / SLV-SE840N / SLV-SX740D / SLV-SX740E / SLV-SX740N service manuals if exist.